K40 CALIBRE Specifications
GROUND
#8 X 1/2" TEK
IGNITION
SWITCHED
+12 VOLTS
BLACK
RED
BROWN
BLUE
GRAY
WHITE
GRA
Y
GRA
Y
WHITE
BLUE
INTERIOR
NETWORK
MODULE
FRONT
RADAR
LED
REAR
RADAR
LED
(CALIBRE DL
model only)
RECEIVER
CABLE
FRONT
AMPLIFIED
SPEAKER
REAR LASER DEFUSER
(OPTIONAL)
+12 VOLT
BATTERY
OR IGNITION
SOURCE
BLUE
YELLOW*
BROWN*
BLACK
BLACK
CABLE
FUSE
CONNECTION
GROUND
#8 X 1/2" TEK
1AMP
YELLOW*
BROWN*
BLACK
FRONT LASER DEFUSER
(OPTIONAL)
+12 VOLT
BATTERY
OR IGNITION
SOURCE
YELLOW*
BROWN*
WHITE
BLACK
BLACK
CABLE
FUSE
CONNECTION
1AMP
GROUND
#8 X 1/2" TEK
YELLOW*
BROWN*
BLACK
RECEIVER
CABLE
REAR
BLOCK DIAGRAM
*THE YELLOW AND BROWN
RADAR RECEIVER WIRES
ARE USED TO CONNECT TO
THE OPTIONAL LASER
DEFUSER. IF NO LASER
DEFUSER IS BEING
INSTALLED WITH THE
RADAR RECEIVER (FRONT
AND/OR REAR), THE YEL-
LOW AND BROWN WIRES
WILL NOT BE USED.
CALIBRE
44586-2 07/07
IGNITION AND GROUND
1. Use a test meter to locate an ignition on source for the Interior Network Module with +12 volts when
ignition key is both on and cranking.
2. Connect the black wire to a solid chassis ground using the provided ring terminal and silver self-
tapping screw.
3. Radar receivers may be connected to either a +12 volt ignition on source or +12 volt constant
battery source.
*NOTE: THE RED WIRE
SHOULD BE CONNECTED
TO A MINIMUM 16 GAUGE
+12 VOLT IGNITION WIRE.