K40 LASER DEFUSERPLUS Installation Instructions Manual

TM

ELECTRONICS

I

NSTALLATION

I

NSTRUCTIONS

LASER DEFUSERPLUS

P

ARTS

K

IT

Parts Kit includes the following:

A- (1) Universal Mounting Bracket

B- (1) Red L.E.D. Laser Alert Light

C- (1) Piezo Beeper w/ “O” Ring Tape

D- (1) Double Stick Tape Strip

E- (2) 36” - 20 ga. Grounding/Power Wires

F- (1) 3 AMP Fuse Assembly

G- (4) Barrel Connectors

H- (2) 1” - 1/4” x 20 Nylon Bolts

I- (2) 1 1/2” - 1/4” x 20 Nylon Nuts

J- (8) 1/4” x 20 Nylon Bolts

K- (2) #6 x 1/4” Screws

L- (3) #10 x 3/4” Screws

M- (1) 1/2” Self Tapping Screw

N- (1) 22-16 ga. Ring Terminal

IMPORTANT - PLEASE READ BEFORE INSTALLING 

When installing the Laser DefuserPlus outside of the system’s license plate frame, the unit should be mounted as

close to the center of the vehicle as possible, without obstruction. The mounting location of the Laser DefuserPlus 

is important, as police laser gun operators are trained to aim for the flat, reflective surface of a targeted vehicle’s

front license plate. In states that do not require a front license plate, operators will traditionally aim for the front,

center of the vehicle. This procedure allows the operator to effectively "bounce" the laser signal back to the gun 

to calculate the vehicle’s speed.

A

C

E

D

F

G

H

I

J

K

L

M

B

N