Summary of SAPPHIRE
Page 1
“sapphire” bark control collar user guide.
Page 2
Introduction: the our k9 sonic & vibration bark collar stops barking with progressively increasing longer sonic blasts and vibration which is controlled by a microprocessor and automatically delivers correction after each bark. It does not work off the sound of your dogs bark but from air pressure d...
Page 3
What the bark collar actually does when your dog barks our k9 vibration bark collar can be adjusted to control the sensitivity of your dogs bark, according to the size of your dogs bark if your dog does not bark within the 40 sec limit then the collar will revert back to number 1. The use of the war...
Page 4
Putting the collar on your dog: switch the collar off so the collar has been disabled. And adjust to the correct length, (there is a short video to help you if needed) the prongs must be against your dog's skin to work, and the hole must be free of any obstruction.… if for any reason you took your c...
Page 5
Now leave the collar on your dog, do not switch the collar on…. Wait for 24 – 48 hours until your dog totally ignores the collar, initially they will scratch at it and just paw at it, when that completely stops we are ready to start the training. Remove the collar from your dog, you must be prepared...
Page 6
Just hold it up with the back of the collar facing you, there is a small hole between the two prongs, just puff into the hole and the collar will make a beep sound, do it again, and the collar will again make the another beep sound. Now do it a third time and the collar will make the beep sound agai...
Page 7
Now we are going to start the training, under no circumstances should you just put the collar on your dog and leave it them to figure out, your dog will get confused and extremely upset. You must teach them what you expect from them. Now please watch the training video, remember every time your dog b...
Page 8: Charging Your Collar
What the lights on the collar mean red and green lights flashing - collar is in reset mode this will last for 1 minute green flashing light - collar is in stand by mode to turn on your collar - hold down the on/off button for a green solid light - collar is in working mode how to turn on / off your ...
Page 9
Caution notes: 1.You must remove the collar daily, clean and gently massage your dogs neck . Because the collar is quite tight you must remove it daily to avoid any likelihood of your dog developing any pressure sores 2. When charging the collar…. You must gently remove the rubber cover to access th...
Page 10: Fault Finding Guide
Fault finding guide q. The green light on the collar keeps flashing a 1. This is normal, this means that the collar is in active mode and is alert. When the green light stops flashing is means that the collar has gone into standby mode. So when your dog sleeps the collar sleeps, when your dog is awak...
Page 11
Q. My dog barks but the collar does not activate... A 1. Dead battery - check the battery by performing a full test. Refer page 3 q. My collar keeps coming loose… a. Sorry but the collar has been put together incorrectly. The collar has been tested to 90lb breaking and slippage. Please watch our vid...