Cdx-09 tm installation & operating instructions please read all instructions carefully before putting your cdx-09 into operation..
Table of contents introduction .................................................................................. 1 cdx-09 operating instructions ............................................... 1 to open from outside ........................................................................ 1 to open ...
1 i ntroduction the combination door unit can be added to the x-09 lock to form the cdx-09. This adaptation allows you to have access control on any door. Please read all instructions carefully before attempting to install and operate your cdx-09 lock assembly. Cdx-09 o perating i nstructions please...
2 to open the cdx-09 from the inside 1. Turn the release knob to the left (counterclockwise) to withdraw the dead bolt. Note: when closing the cdx-09, the dead bolt will not extend until the release bolt hits the door strike as the door closes. Life safety operation the life safety feature (bolt sto...
3 cdx-09 i nstallation i nstructions please read all instructions carefully before you install and use your cdx-09 lock assembly. This will help you avoid unnecessary costs and concerns resulting from improper installation. Basic tools needed 1. Medium phillip’s screwdriver (#1/#2). 2. Standard hack...
4 installation kit contents 1. Blade, saw (52 teeth/inch) 2. Handle, saw 3. Tube, outer 4. Tube, inner 5. Dial ring attaching locknuts, #8-32 (2). (packaged with exterior mounting plate - used with drill resistant mounting plate) 6. Rubber vise clamp 7. Cdx-09 to door mounting screws, pan head #10 x...
5 cdx-09 parts for installation 1. Cdx-09 dead bolt lock assembly 2. Cdx-09 base hardplate 3. Dial hub assembly 4. Strike kit (1 of 4 types: 1, 2, 3 or 9; strike #9 is shown in photo with screws) 5. Spindle 6. Dial ring assembly 7. Dial assembly 8. Exterior mounting plate cover 9. Exterior mounting ...
6 strike installation 1. Refer to the enclosed strike information sheet for your specifi c strike mounting details. 2. Mount the strike on the door jamb at a convenient height above the fl oor. This should not exceed 47 inches from the fl oor to the center of the strike. 3. Make sure the strike is m...
7 12. Feed the cable and outer tube through the 1/2" hole in the door while positioning the cdx-09 and hardplate against the door. Insert the two (2) #10 screws nearest the strike opening to attach the cdx-09 and hardplate to the door. 13. Position the exterior (dial ring) mounting plate and insert ...
Document number 525.021 rev. C 9/08 notice: the information in this manual is subject to change without notice and does not represent a commitment on the part of kaba mas. Kaba mas shall not be liable for technical errors or omissions contained herein; nor for incidental or consequential damages res...
