Drive assembly installation instructions simplex ® 3000 series.
2 package contents: tools required for installation (1) drive assembly (1) cam plug (adams-rite #4580) (1) cardboard template (1) cam plug cover ( 31 / 32 " backset only) (2) mounting screws 10-24 thd x 1 1 / 2 " (2) threaded sex nuts (2) mounting bushings • tape • electric drill (variable speed rec...
3 a. Hardware disassembly a-1 remove adams-rite face plate from edge of door exposing the cylinder set screws (see figure 1). A-2 loosen the cylinder set screw (securing key cylinder to adams-rite latch) and remove the mortise cylinder from the dead latch assembly (see figure 1). A-3 with the except...
4 b. Stile preparation for combination side of door b-1 install adams-rite cam plug #4580 to the adams-rite dead latch. Snug tighten the cylinder set screw (see figure 1). See section e-1 for final screw adjustment . B-2 position the cardboard template (locate on cam plug pins) as shown (see figure ...
5 c. Stile preparation for trim plate side of door (trim plate assembly is included in lock housing box marked 3001 or 3002). C-1 secure an adams-rite cam plug #4580 to the trim plate side of the dead latch assembly. Note: installation of this cam plug will require the opposite handing as used on th...
6 kaba simplex ® limited warranty kaba access control warrants this product to be free from defects in material and workmanship under normal use and service for a period of one (1) year. Kaba access control will repair or replace, at our discretion, locks found by kaba access control analysis to be ...
K a b a a c c e s s c o n t r o l 2 9 4 1 in d ia n a a v e n u e w in s t o n -s a l e m , n c 2 7 19 9 -3 7 7 0 no po s t a ge ne ce s s ar y if mailed in the united s t a te s b u s i n e s s r e p l y m a il f ir s t -c l a s s m a il p e r m it n o . 15 6 3 p o s t ag e w il l b e p a id b y a ...
T hank y ou for pur chasing our pr oduct . In or der to pr o tect y our in v e s tmen t and to enable us to be tt er s e r v e y o u in th e fu tu re , p le a s e fi ll o u t th is re g is tr a ti o n c ar d and r e turn it to k ab a a c c e s s c on tr ol, or r egis ter online at www .K ab aac c e ...
7 notes.
8 d. Drill lock and trim plate mounting holes d-1 remove adams-rite cam plug(s) and adams-rite dead latch assembly from door (see figure 7). (this will prevent chips from entering the latch.) d-2 you are now ready to enlarge pilot holes marked a, b and c on both sides of stile. Enlarge holes to size...
9 e. Hardware assembly e-1 re-install adams-rite dead latch assembly. Re-install adams-rite cam plug or plugs (do not tighten cylinder set screw) (see figure 9). E-2 locate the drive assembly on lock side of door over the pins on the adams-rite cam plug. Secure lower portion of drive assembly using ...
Kaba access control 2941 indiana avenue winston-salem, nc 27105 usa tel: 800.849.8324 or 336.725.1331 fax: 800.346.9640 or 336.725.3269 www.Kabaaccess.Com pkg2582 0909.
