Kaba access control 2941 indiana avenue winston-salem, nc 27105 usa tel: (800) 849-8324 (336) 725-1331 fax: (800) 346-9640 (336) 725-3269 www.Kabaaccess.Com pkg1819 0307 900 series installation instructions.
Checklist each 900 series lock includes: a) lock housing assembly b) face plate with outside knob c) strike plate (for outswing doors) d) strike box (for inswing doors) e) screw/accessory pack: a) holding bracket b) three 1 1 ⁄ 2 " (38 mm) screws for the lock housing c) two 1 ⁄ 2 " (13 mm) screws fo...
5 c. Drilling the holes caution: positioning and drilling must be done straight to avoid excessive force being exerted on the lock which may result in the premature wearing of its mechanical parts. Note: the latch is reversible on spring latch models 917, 919, 935, 938, and 929. Refer to the instruc...
E-5 remove the three screws holding the lock housing to the door, then remove the lock housing. E-6 slide the holding edges of the face plate (d) behind the formed-up edges of the holding bracket (a) (see figure 5-5). Make sure that the face plate (d) is securely held on both sides. If you are insta...
9 g. Testing the lock’s operation important: the following steps must be performed while the door is open. Unlocking the door g-1 turn the outside thumbturn to the left (counterclockwise) to the stop position and release (see figure 7-1). G-2 enter the preset combination (ii and iv depressed togethe...
Kaba simplex ® limited warranty kaba access control warrants this product to be free from defects in material and workmanship under normal use and service for a period of one (1) year. Kaba access control will repair or replace, at our discretion, locks found by kaba access control analysis to be de...
10 h-2 enter the existing combination (see figure 8-2). On new installations, use the factory-set combination: depress ii and iv simultaneously, (release), then iii (release). You should feel a slight click as each button is depressed. H-3 use the allen wrench (item d on checklist) to remove the scr...
12 j. Instructions for resetting unknown combinations follow the instructions in section i, “disassembling the lock.” remove the lock from the door and disassemble it as instructed (see figure i-1 to i-4). To remove the 3-sided dust cover marked "kaba simplex," place the combination chamber in the p...
14 13 j-12 once you have depressed all the digits in this new combination, turn the control shaft (d) clockwise (see figure 10-4). The code change button (h) under lockout slide (g), should pop up (see figure 10-4). The combination is now set back to factory 2 and 4 together, then 3 (this will be ev...
15 14 notes top for righ thand doors attach to inside surface of shut door door handing should be determined before door prep is started to avoid incorrect door preparation. Door handing should be determined before door prep is started to avoid incorrect door preparation. Attach to inside surface of...
