Kabuto Aeroblade-III Instruction Manual - Single Action Shield System
ENG
Shield
※シールドが止まる一番上まで上げる
Move the shield up as far as it goes.
Fig.1
Fig.2
Release Button
Release Button
a
Pressing down the button
a
Pressing down the button
Release
button end
1 0
The “Single Action Shield System
PATENTED
” is the shield replacement system developed
by KABUTO. The system allows quick shield replacement for riding and racing
conditions and easy maintenance.
6
Single Action Shield System
PATENTED
WARNING!
●Operating the shutter while riding is very dangerous. Never operate the
shutter while riding. Operate it before riding.
●The air-ducts (air intakes and discharge holes) of the head ventilations and
the rear ventilation are designed in the proper sizes and quantities
considered a large impact in the event of accidents and falling down.
Customizing by enlarging or making more air-ducts would reduce the safety
performances significantly and can cause serious injuries in case of an
accident. Never customize your helmet.
CAUTION
●The shield is so constructed that it cannot
be removed unless it is moved up to the
highest position.
●Do not pull or twist the shield by force to
remove it. Such action may damage the
shield and ratchet system.
●●Handle the removed shield with care in
order not to damage it.
Repairing the ventilations
When each ventilation is damaged, contact your local authorized Kabuto
dealer. (See Pages 23 to 25).
Please be informed that we may not accept repairing, in the case the safety
performance of the helmet will be degraded.
–How to remove the shield–
Move the shield up (Fig. 1). (Move it up as far as
it goes.)
As shown in Fig. 2, pull the shield in the direction
of the arrow while pressing down the release
button on the shield. One side of the shield is
completely removed.
The shield can be removed easily by pulling it
along the angle of the end of release button.
Repeat the same procedure for removing the
other side of the shield. Then the entire shield
can be completely removed.
Pull it towards
the angle of
button end
ENG-10
WARNING!
CAUTION!
Single Action Shield System
PATENTED
The “Single Action Shield System
PATENTED
” is the shield replacement system developed
by KABUTO. The system allows quick shield replacement for riding and racing
conditions and easy maintenance.
–How to remove the shield–
Move the shield up (Fig. 1). (Move it up as far as
it goes.)
As shown in Fig. 2, pull the shield in the direction
of the arrow while pressing down the release
button on the shield. One side of the shield is
completely removed.
The shield can be removed easily by pulling it
along the angle of the end of release button.
Repeat the same procedure for removing the
other side of the shield. Then the entire shield
can be completely removed.
●The shield is so constructed that it cannot
be removed unless it is moved up to the
highest position.
●Do not pull or twist the shield by force to
remove it. Such action may damage the
shield and ratchet system.
●Handle the removed shield with care in
order not to damage it.
a
b
*
c