Kahuna LM-8800 User Manual - page 10
Power jack
Preparation before Use
Power on/off
*Insert the power cord into the power jack.
*Plug the power cord.
*Turn on/off the main switch on the back
of TAMI.
! Caution
*Make sure the power cord is not placed
under TAMI.
*Make sure that all switches (including
the main switch) are turned off before
plugging.
Inspect the backrest pad
*Lift the backrest upholstery to ensure
that there is no hole or tear on the
backrest pad.
! Caution
*Often inspect to ensure there is no
broken hole or crack. It shall immediately
stop using TAMI, unplug it and contact
the service center for thorough inspection
once the backrest pad is found with
cracks even minor ones.
Attention
*If the rollers are located in the middle
of the backrest when operation is
stopped, they will return to the storage
position when the main switch is turned
on again.
Move TAMI
Castors
The second way(2)
!
*Do not move TAMI while someone is
sitting in it. This will cause overturn of
TAMI and result in accident or injury.
*Be award falling of the foot massage
unit while moving in order to avoid causing
injury. It suggests that the foot massage
unit is held by someone!
9
TAMI is fitted with castors for facilitating
move.
*The massage armchair can be moved
in two ways.
The first way(1)
*Raise the backrest to the fully upright
state, turn the chair cushion upwards,
and then turn the foot massage unit
upwards as shown in the figure.
*Turn off the main switch off and unplug
the power cord.
*As shown in the following figure, put up
parts on both sides of the front of
armchair and move the armchair to the
desired position.
*Raise the backrest to the fully upright
state, turn the chair cushion upwards,
and then turn the foot massage unit
upwards as shown in the figure.
*Turn the main power switch off and
unplug the power plug.
*Move the massage armchair as per
the following figure.
Caution
!