KaiDeng WVC User Manual - page 6
4
Female contact of lunk
Connect to Modem serial port
2. Connect the serial port of the male contact of lunk to computer main chassis’s serial port and tighten the screw on
both ends of the connections, show likes below:
Male contact of lunk
Connect to computer main
chassis’s serial port
3. Connect the power;
4. Finish installation of WVC Modem;
1. Connect the serial port of the female contact of lunk to WVC Modem serial port and tighten the screw on both ends of
the connections, show likes below:
When the micro inverters is less than or equal to 100pcs in generation system, we only need to install one WVC Modem.
The installation is very simple, just need using the serial port to connect the WVC Modem and computer, then plugged in
power. Of course, the first premise is your computer needs a serial port(If there are no RS232 interface on your computer
you need to buy the USB To RS232 connector then use the USB port to communicate directly.). And the details installation
like below:
2.3 WVC Modem Installation