Kaisai KHP-2.4/D270 Installation And Service Manual - page 94
Manual is about: air source heat pump water heater
of
108
94
www.kaisai.com
EN
6. OPERATION INSTRUCTIONS
6.1 On/Off Setting
The unit will be started or stopped by pressing the “On/Off” button.
Note:
After energization and under normal communication, the LCD will display the water tem
-
perature, time, and hot water volume (for models with dual temperature sensor) under both On
and Off states of the unit. It means the Off state if the LCD does not display the running mode, as
shown in the following figure.
6.2 Common Modes Setting
In the On state of the unit, press the
MODE
button to switch the operation modes in the following
sequence:
The HOTWATER mode is shown in the following figure.