Kaiser Baas ALPHA User Manual - Set Up

Set up  

Charging

Plug your USB charging cable into a powered USB port 

(wall adaptor not included).  When connected correctly, 

the USB plug will glow red. Connect your battery to the 

USB charging cable.  When charging correctly, the red light 

should turn off. The red light will turn back on once charging 

is complete (to avoid shortening battery life, do not remove 

the battery from charge until charge sequence is complete). 

Initial Assembly

Alpha Drone Feet 

Insert the feet into the guide holes on the underside of 

the Alpha Drone, in the allocated position.  Push the Alpha 

Drones feet into the underside of the body until the feet are 

secure and flush against the body of the Alpha Drone.   

Rotor blade guards 

Insert rotor blade guards into guide holes in the allocated 

position.  Use the included screwdriver to secure the 

propeller guards to the Alpha Drone, making sure not to 

over-tighten.   

Camera 

Ensure that the camera cable is connected to the Alpha 

Drone and insert the Micro SD card* into the allocated slot.  

Battery 

Slide the battery hatch out on the Alpha Drone and lift 

gently to open. With the Alpha Drone turned off, insert the 

battery into the opening with the cable end facing outward, 

ready for connection. Plug the battery cable into the socket, 

then close and lock the hatch by sliding gently back in place.

*

Micro SD card not included

13

English