Kajeet Sprint User Manual - page 37

Re

gulator

y Informat

io

n

Section 3B. Regulatory Information

29

䢇

International Commission on Non-Ionising Radiation Protection (ICNIRP) 1998, 

Guidelines for limiting exposure to time-varying electric, magnetic, and electromagnetic fields (up to 

300 GHz)

FCC ID

: N7NC597

CAUTION:

 The Compass 597 USB modem has been tested for compliance with FCC / IC 

RF exposure limits in the laptop computer(s) configurations with a horizontal USB slot and 

can be used in laptop computers with substantially similar physical dimensions, 

construction, and electrical and RF characteristics. This USB modem must not be co-

located or operated in conjunction with any other antenna or transmitter.

Use of this device in any other configuration may exceed the FCC RF Exposure 

compliance limit. 

NOTE:

 If this USB modem is intended for use in any other portable 

device, you are responsible for separate approval to satisfy the SAR requirements of Part 

2.1093 of FCC rules.

NOTE: 

If your computer’s USB slot is vertical, use the USB extension cable. Do not insert 

the USB modem into a USB hub or a USB slot on a keyboard.

WARNING:

 If the orientation of your computer’s USB slot or the thickness of your computer 

are such that pressure is applied to the modem’s end or side, you may damage the 

modem or your computer. In such cases, do not insert the USB modem directly into your 

computer’s USB slot; use the USB extension cable instead.

WARNING (EMI) - United States FCC Information

 - This equipment has been tested and found to 

comply with the limits for a Class B computing device peripheral, pursuant to Part 15, 22, 

and 24 of the FCC rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not 

installed and used in accordance with the instructions, may cause harmful interference to 

radio communications. However, there is no guarantee that interference will not occur in a 

particular installation.