KALATEL KTD-400 Installation And Operation Manual - page 13
13
1034790D / January 2001
KTD-400 Controller Keypad Installation and Operation Manual
Multiplexer Enabled
Step 7)
This menu determines which multiplexers can be enabled (accessed) from the
keypad. This menu will only come up if at least one multiplexer is in the system
(see Step 4). To enable a multiplexer, press
1
. When enabled, the multiplexer
select menu display (Step 8) will appear. This must be done for each multiplexer
in the system.
Pressing
0
will advance to the next multiplexer, or the
keys can be used
to move between multiplexers. Press
seq
to advance to the VCR access menu
(see note below).
In Steps 5-7 and 10,
seq
will not advance to the next menu if access to all cameras, monitors,
and VCRs has been denied. At least one camera site, monitor, multiplexer, and VCR must
have access.
NOTE:
Multiplexer Select
Figure 15: Multiplexer Enabled Display
MPLXR 01 ACC=NO
0=NO 1=YES SEQ=NEXT
Step 8)
When a multiplexer has been enabled, this menu allows selection of different
models of multiplexers. Use the
keys to scroll through the list. The models
are listed in alphabetical order. After selecting the appropriate multiplexer, press
seq
to advance to the next menu.
Multiplexer View Display
Step 9)
This menu determines which views will be enabled when the keypad is in
multiplexer operating mode. (When in multiplexer operating mode, pressing the
view
key toggles through the views selected here.) Some multiplexer models do
not have selectable views and will skip this menu.
Use the
key to scroll through the list of views available. For each view, press
1
to accept or
0
decline. When all views have been selected, press
seq
to
return to the Multiplexer Enabled menu display.
Step 6)
This menu is used to deny or permit the controller keypad’s access to certain
monitors. Press
0
to deny access or
1
to permit access. After each selection,
the next monitor number will appear. The
keys can be used to move
between monitors. When done, press
seq
to advance to the next menu.
Figure 17: Multiplexer View Display
VIEW: PIP YES
0=N 1=Y =NXT SEQ=EX
Figure 16: Multiplexer Select Display
MPLX 01: ATV
SELECT( ) SEQ=NEXT