Kalenji CW-400 User Manual - page 9
EN
16
17
EN
8/ Parameter mode (Settings)
The general setting rule is to select the parameter to be set by successively pressing on LAP/RESET
, then to enter the setting
mode by pressing on START/STOP
, then to increase or decrease the value by pressing on MODE or LAP/RESET
and lastly to validate this by pressing on START/STOP
.
Setting the target zone
When entering setting mode of the target zone, the type of target zone is displayed:
- Press down on START/STOP
, you access the setting of the Second Timer REST (rest time). Set the number of seconds using
the LAP/RESET
(+) and MODE buttons (-). Press down on START/STOP
to access the setting of the number of
minutes. Set the number of minutes using the LAP/RESET
(+) and MODE (-) buttons.
- Press down on START/STOP
, you have the option of activating or deactivating the repetition of timers set previously, in order
to do this use the LAP/RESET
(+) or MODE buttons. (-), ON or OFF is displayed on the screen.
If “ON” is selected press down START/STOP
, you will access the setting of the number of repetitions of the timers.
Set it using the LAP/RESET
(+) and MODE buttons (-).
Once you have set the parameter, you have two options. If you want to set other heart rate parameters, once you have returned
to the SET TIMER display, press down once on LAP/RESET
. If you want to exit the SETTINGS mode, press down once on
the MODE button .
Practical information:
- When setting things, the LAP/RESET
button enables the value to be increased and the MODE button
enables it to be decreased.
- To set things more quickly, you can keep LAP/RESET
or MODE pushed in and the values will change
rapidly.
- If no button is pressed for 2 minutes during setting, the watch automatically exits setting mode.
Either the target zone is deactivated (ZONE: OFF) or it is activated and expressed in beats per minute (BPM) or as a percentage of
the maximum heart rate. The watch will then alternately display the selected mode and the zone values.
Modification to the upper and lower levels in one of the two display modes will be automatically converted to the other mode.
If you want to modify the target zone mode to be used, select it using START/STOP
, then change it by pressing down LAP/
RESET
. Validate your selection by pressing again on START/STOP
, you will then access the setting mode for the
target zone values.
Activating/deactivating the timer repetitions:
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Setting the timer
The TIMER mode is set within the SETTINGS mode, press down the Mode button several times to access it.
Once you are in SETTINGS, these are the steps to take:
- Press down on LAP/RESET
once, SET TIMER appears on the screen.
- Press down on START/STOP
, you access the setting of the First Timer RUN (workout). Set the number of seconds using the
LAP/RESET
(+) and MODE (-) buttons.
- Press down on START/STOP
to access the setting of the number of minutes. Set the number of minutes using the LAP/
RESET
(+) and MODE (-) buttons.