Kalibr EKO 1000 Instruction Manual - page 2
2
1. Put the heater upside down, fix the foot the bottom of the heater, make sure
the screw holes are matched correctly, then tighten up the screw.
2. Stand up the heater.
Mounting on the wall:
1. Fix bracket(c) to the wall using the plugs and screws provided.
2. Position to allow a minimum of 50cm clearance from the base of the
produce to the floor and 50cm clearance from the top of product to the
ceiling,ensure that it is positioned at least 1m from soft furnishings and
curtains. According to the holes position on the bracket, Mark the holes
position where the bracket will be fixed on the wall. Drill the holes on your
wall according to you marked, make sure the diameter of the holes is
suitable for screw. Insert the screw and fix the bracket, Place the heater on
the bracket and lock it via the locking sheet. Fix the locking sheet and
bracket with the M4×8 screw between.
B
A
D
C
>
50
cm
>
50
cm
Lock sheet
M4×8 Screw
Instruction:
1. The thermostat switch On the thermostat switch there is “L”(low )
H” (high) printing, rotate the
switch, as arrow pointed
①
”Low” The lowest setting temperature(Remark :when surroundings
temperature is not below 0℃ ,the thermostat is disconnect condition.)
②
:High”: The highest setting temperature.
Remark: With this switch you rotate the thermostat switch from “L” to “H”,
the thermostat operate once heard a sound like “click” ,turn the switch to
your desired temperature control condition.
2. The power switching knob on the power switching knob , there are printed
0
, rotate the switch, as arrow pointed
a “ ” : the device is turned off
b "
” : anti-frozen mode
c “
”: economical mode