KAM BDX400 Instruction Manual - page 4
Precautions
The apparatus should not be exposed to dripping or splashing, and no objects filled with liquids such as vases
should be placed on the apparatus. Do not use any spray cleaner on any of the controls or switches.
Always, begin with the audio level faders/volume controls set at minimum and the speaker volume control(s) set to
OFF. Wait 8 to 10 seconds prior to turning up the speaker volume to prevent the transient “POP” that
could result in
speaker/crossover damage.
Voltage selection
Rotate the platter (2) until the voltage selection switch (3) (located on the turntable base (1)) is visible through
one of the platter holes. Make sure that the voltage selector switch is set to the correct voltage.
WARNING: If you try to operate the turntable with the incorrect voltage setting, it can damage your turntable.
Turntable installation
1. Put the slip mat (4) on the platter (2).
2. Set the turntable base (1) on a flat, level surface free of vibration. Use the turntable feet to stabilize the unit
horizontally.
3. Try to place the unit as far away from the speakers as possible.
4. Keep the unit away from direct exposure to the sun, heat, moisture or dirt.
5. Keep the unit well ventilated.
Cartridge installation (Fig.1)
Because all cartridges have their own designs, please refer to your particular cartridge’s instructions to insure proper
installation. If you are using a pre-mounted or integrated cartridge, you can jump ahead to headshell installation.
1. Connect the lead wires to the cartridge terminals. For your convenience, the terminals of most cartridges are color-
coded. Connect each lead wire to the terminal of the same color. In case your cartridge is not marked, the positive
leads are the ones on top, negative below, left are left, and right are right.
White (L+) Left Channel +
Blue (L-) Left Channel –
Red (R+) Right Channel +
Green (R-) Right Channel -
2. Mount the cartridge in the headshell (5) and tighten it with the screws included with the cartridge.
Headshell installation
Insert the headshell (5) into the front of the tubular tone arm (7). While holding the headshell (5) firmly in a
horizontal position, turn the locking nut (6) counter clockwise until the headshell (5) is locked in place.
Counterweight installation (FIG. 2)
1. Slide the counterweight (8) onto the rear of the tone arm (7) with the numbered stylus gauge facing forward.
2. Twist the counterweight (8) counter clockwise lightly, to screw it onto the rear of the tone arm (7).