KAM DMX LASER 120 PRO Instruction Manual
i n s t r u c t i o n
m a n u a l
w w w . k a m . c o . u k
Remarks:
DIP SWITCH NO.1 & NO.10 in “ON” control via
dmx controller
DIP SWITCH NO.1 & NO.10 in “ON”.
The mini-controller can be use to control the
laser light.
When using DMX, the mini-controller function
is not available. When using mini-controlle
control, the DMX is not available.
When not using any controller to control laser
, set DIP SWITCH No.1 “ON”, then the laser light
will be in automatic mode
Link laser to master & slave by DMX control,
Master & slave DIP SWITCH setting to No.1 &
NO.10 in “ON”, then all lasers will show same
patterns & work together in sync.
Link laser to master & slave by DMX control,
Master laser DIP SWITCH setting to No.1 & NO.10
in “ON”, slave lasers DIP SWITCH setting will
follow laser function
Use DMX channel binary numbers to set
different head addresses in each unit. Then all
lasers will show different patterns via DMX
controller programming
When no using any controller to control laser,
the laser will be in automatic and sound active
mode. The laser can be linked in master and
slave mode. From master 5-XLR to slave 3-XLR.
THE DIP SWITCH SETTINGS
Master DIP SWITCH address: NO.1
and NO.10 in “OFF”.
All slaves DIP SWITCH address: NO.2 in “ON”.
The DMX LASER 120 PRO is designed with a
blackout function.
A: When no sound is present the laser will go into
blackout mode
B: When the sensitivity is set to low the laser will
go into blackout mode
C: When no DMX signal, the laser will go into
blackout mode
D: When OFF DMX signal, the laser will go into
blackout mode
E: Under DMX signal control to Manual with
sound active mode, blackout function is not
available.
Technical Specification
Operation Voltage: AC 220/240V/50Hz
Working power: 30W
Laser Wavelength: 532nm
Laser power: 120mW
Laser class: Class IIIb
Fuse: 3A F
Insulation Resistance: >2M
Channels: 12 channels
Control signal: DMX512 signal
Control mode: Mini-Controller/Sound
active/Automatic DMX Linkable
Net weight: 4.20Kg
Dimensions: 225x300x280mm
Attention: The laser light is designed indoor use
only Working temperature in 10° ~ 60°C.
Due to continuous product
development, specifications
and appearance are subject to
change. E&O E.