KAM Energy SD1 Instruction Manual - page 6
Important: To access ALL the option in the secondary menu, ensure that you have selected Multi-colour in the Projector
setting and set the Scanner rate to 20K and then Saved these options. This will allow you to change between all of the available
settings in the secondary menu. If, for example, Single colour is selected in the first menu (the Projector setting menu), then this
will be the only option available in the secondary menu. If RGY is selected in the first menu then both the single colour option and
the RGY projector settings will be available in the secondary menu (but not the multicolour option).
Language setting
If you need to change the language for any reason, please use the following instructions. Immediately after turning the unit on
(when the version number info appears on the Information Display (4)), press in and hold the Menu Control knob (9) for two
seconds. To choose your preferred language, rotate the Menu Control knob (Simplified Chinese, Traditional Chinese, English and
Japanese). To make your selection, press the Menu Control knob to confirm.
Standard operation settings
When the unit has been set to its recommended settings (see above), it is now ready to start operating. To change the unit’s
mode settings, hold down the Menu Control knob for three seconds and the secondary menu will appear. The menu comprises of
Mode, Setting, Sensitivity, Back and Exit.
1. Select the Mode from the menu options
2. Choose PRG ILD (
this will access the ILDA files as a list on the SD card)
3. Next select Setting and scroll down to Colour Setting and choose the Multi-colour option
4. Finally select the Exit menu
IMPORTANT: Ensure that Sound active in the Mode menu is NOT selected if Sound-to-Light operation is not required. The unit
requires audio of a reasonably high volume to work in Sound-to-Light mode. If the music or audio is too quiet, the animations may
tend to stall. The sound sensitivity in the Sound Active mode can be adjusted to make it more sensitive to sound with a range of
1, the least sensitive to 87.
The layout for the secondary menu is illustrated below:
Mode
ILD show
X mirror
Sound range
0-87
Save
change
Y/N
Y mirror
Colour setting:
Single colour
RGY
Multi-colour
Scan rate
Play speed
Exit
Setting
Sensitivity
Back
PRG ILD list
Built-in show
DMX
Sound active
Exit
Exit
The available Settings may differ from the above depending on which Mode is selected in the menu.