KAM KAP1200 USB Instruction Manual - page 6
29. Brake - When the button is illuminated a brake effect is activated, pressing the play button while the track is playing will
slowly bring the track to a stop. Pressing the play button in pause mode will start the track slowly the will climb to correct
speed.
30. Reverse - When this button is illuminated the track will play backwards.
31. Time - This button will toggle between time elapsed and time remaining, this will be displayed in the screen.
32. Tap - Press the tap button continuously to the beat of the music to activate the manual BPM counter, this will determine
the speed of the track and give a visual BPM (beats per minute) value in the display.
33. Play/pause - This button will play or pause the track.
34. Mains power cable input
35. Balanced outputs - Connect balanced XLR leads to the amp. Controlled by master volume slider.
36. RCA master outputs - Connect RCA/phono leadsto the amp. Controlled by master volume.
37. Booth - Connect RCA/phono leadsto the amp. Controlled by booth volume.
38. Rec - ConnectRCA/phono leadsto a tape deck or recording device.
39. Source inputs - Connect either phono or line level inputs here. Please note phono is for turntables only, these must not
be connected to a line level source input. Likewise line level source must not be connected to phono inputs.
40. Earth - Use this tag to connect the earth tag lead on turntables to reduce audio hum. This is for turntable earth only and
should not be used as a main earth grounding point.
Specifications
Input terminal (input level/impedance)
CD/line
300mV/22k
Phono
5mV/47k
Main mic
5mV/3k
Mic
5mV/3k
Frequency characteristics
CD/line/phono/mic
20Hz to 20kHz
SN ratio
CD/line
86dB (with effects off)
Phono
76dB
Mic
69dB
Total harmonic distortion rate
CD/line/phono
76dB
Cross talk
Over 70dB
Channel equalizer
Hi
+12dB, -24dB (13kHz)
Mid
+12dB, -24dB (1kHz)
Low
+12dB, -24dB (70Hz)
Microphone equalizer
Hi
+12dB, -12dB (10kHz)
Mid
+12dB, -12dB (1kHz)
Low
+12dB, -12dB (100Hz)
Power supply voltage
AC100-240v (10kHz)
Power consumption
20w
Operating temperature
+5 c to +35 c
Operating humidity
5% to 85%