KAM Kompact 12 Pro Instruction Manual - page 4
1.
Left and right outputs
Output signal - this supplies a full range output signal to connect an additional full range active cabinet or
Kompact 12 Pro system.
2.
Left and right channel XLR / jack line inputs
Connect your input source via jack / XLR from your mixer or other line level audio source (CD / radio / etc)
3.
Left and right amplified outputs
Connect to the left and right satellite speakers using the speakeron cables supplied. Insert the speakeron
plug and then turn clockwise to click and locate the plug correctly. To remove the speakeron plug slide back
the silver metal catch, then turn anti-clockwise to release the plug.
4.
On / Off power switch
Press to power the speaker cabinet on / off.
5.
Subwoofer volume control
Adjust the volume control to the desired level, make sure the unit is not driven in clip mode.
6.
Phase
The phase switch electrically reverses the polarity of the subwoofer and thus changes the phase angle by
180 degrees, reversing + and – input signal. This is sometimes useful in cases where the subwoofer output
is electrically out of phase with the mid-high speaker outputs. Let your ear be the judge as to which position
allows your subwoofer and speakers to perform optimally. Usually there is a drastic and obvious difference
between both settings. If you hear no difference, then keep the switch set at “normal”.
7.
Satellite volume controls
Use these to adjust the volume of the left and right satellite speakers.
8.
Power LED
When illuminated shows the sub unit is powered from the mains.
9.
Clip indicator LED
If this LED is lit it means your signal is clipping. To stop the signal from clipping, lower the volume to the
point where the LED is blinking along with the bass beat.
10. AC power
Connect a suitable mains supply, check the voltage selector switch is in the correct position for your mains
voltage supply. DO NOT TURN THE UNIT ON UNLESS THE VOLTAGE IS CORRECT.
Technical specification
650w Powerful and portable PA speaker system
Includes 2 x satellite speakers and active subwoofer
Satellite speakers
Full range passive speaker box
Power handling: 2 x 150w continuous RMS
2 x 300w program power | 2 x 600w peak power
6.5 inch driver diameter
Compression tweeter
Frequency response: 80Hz-20 kHz
Sensitivity: 93dB 1W/1M
Impedance: 8 Ohms
Connection: 2 x Speakeron
35mm pole mount
Dimensions (WxHxD): 200 x 410 x 200mm each
Weight: 6Kgs each
Active subwoofer speaker
Power handling: 350w continuous RMS
700w program power | 1400w peak power
Connection: XLR male & female / 1/4 inch jack
Audio input connection: XLR
Audio output connection: Speakeron
Audio thru: XLR
Steel woofer chassis
Frequency response: 30Hz-120Hz
Sensitivity: 94dB (1m/1w)
Fuse rating: 20mm, 6.3A
Rated voltage: AC 115V-230V Switched
Leads supplied: UK/Euro IEC
Dimensions (WxHxD):400 x 450 x 415mm
Weight: 24Kgs