KAM LED Rodeo Instruction Manual - page 3
Operation
There are four ways to operate this unit:
Auto mode
Sound activated (Sound-to-Light) mode
Via a universal DMX controller
Master/Slave mode / Standalone operation
Auto mode and Sound activated (Sound-to-Light) mode
To operate the unit in either of the above modes, use the Function Setting buttons on the rear of the unit. Start by pressing the Menu
button to select your desired effect from the table below e.g. A1 mode (Auto 1 red), then use the Up and Down buttons to select the
speed of the effect 1-9 (slow to fast). Then press the Enter button to save your changes.
Manual setting mode:
A1 mode
Auto 1 setting (red)
Speed 1~9
A2 mode
Auto 2 setting (green)
Speed 1~9
A3 mode
Auto 3 setting (blue)
Speed 1~9
A4 mode
Auto 4 setting (amber)
Speed 1~9
A5 mode
Auto 5 setting (white)
Speed 1~9
A6 mode
Auto 6 setting
Speed 1~9
A7 mode
Auto 7 setting (flash)
Speed 1~9
A8 mode
Auto 8 setting (no flash)
Speed 1~9
S1 mode
Sound active 1 setting
Speed 1~9
S2 mode
Sound active 2 setting (flash)
Speed 1~9
S3 mode
Sound active 3 setting (no flash)
Speed 1~9
L mode
Under sound active condition, no music status light off, setting (L 0)
Under sound active condition, no music status light on, setting (L 1)
d mode
DMX setting
Universal DMX controller operation
When using a universal DMX controller to control a chain of units, you have to set the address using the DMX table below.
Master/Slave operation
Multiple units can be linked together in a daisy chain and operated in Master/Slave mode. Please use a 3 pin XLR cable/plug when
connecting multiple units together in Master/Slave mode.
Master unit: select Auto or Sound mode on the Master unit.
Slave units: select DMX mode and set the start address to d001.
In Master/Slave mode please refer to the DMX settings using the table below.
DMX code setting: d001~d512