KAM Mood Cluster Instruction Manual - page 4
FRONT PANEL
NO. NAME
DESCRIPTION
1
Laser
Aperture
The laser effect output aperture.
NEVER LOOK INSIDE THE
FIXTURE THROUGH THIS
APERTURE WHILE FIXTURE
IS OPERATING.
2
LED Aperture
The LED effect output aperture.
REAR PANEL
NO. NAME
DESCRIPTION
1
Main Power Input
IEC socket and integrated fuse holder.
2
Power Switch
ON and OFF switch
3
Key Switch
Safety key switch unit will not operate with this turned off
4
Interlock
Used to connect an optional emergency stop button. When the contact is closed the
laser will Black-out immediately. This must be wired by a qualified engineer
5
DMX input
3 pins male XLR connector
6
DMX output
3 pins female XLR connector
7
Microphone
To detect the music/sound signal
8
LED Speed
LED effect rotating speed
9
Mic Sensitivity Knob
Turning this knob clockwise increases the sound sensitivity
9
Mic Sensitivity Knob
Turn the knob (potentiometer) until the laser works in sync with the music.
10
Control Panel
To control the fixture with digital LED display, check more information on CONTROL
& FUNCTION
11
Cooling
Forced air fan cooling
12
Safety eyelet
Attach safety chain or rope to this point
OPERATING MODE
When laser is powered on, LED monitor on rear panel shows the current operating standalone mode or
DMX address of DMX mode. With help of LED control panel, it is very easy to set and change the
operating mode of laser. After every resetting and saved, the new mode information will be shown on LED
monitor at next power on.
Mode/Function Option, to choose the operating mode of laser.
Confirmation - to confirm all settings or change of LED control panel.
UP/DOWN, to change operating mode, parameter or DMX address.