KAM Partybar Eco Instruction Manual - page 3
Unit features & functions
Number Feature
Function
1
Power supply input
Attach the IEC mains cable here. Built-in fuse.
2
DMX input
3 pin XLR connector for DMX512 input communication.
3
DMX output
3 pin XLR connector for DMX512 output communication.
4
LED display
LED function display and menu buttons to control the operating mode of the unit.
5
MENU buttons
MENU function buttons x 4 (see below for operation).
6
Mic
Built-in microphone for Sound-to-Light operation.
7
Par can mounts
Attach the par can lights to the controller bar at the 4 points shown.
8
Par can connections
Attach the par can cables to the controller bar at the 4 points shown.
9
Light stand socket
Tighten screw to secure the controller bar to the light stand.
Function setting
Using the four function buttons on the controller bar you can set the operating mode of the unit. Press the Menu button to display
the different functions (see table below for a description of the functions). Use the Up or Down arrow buttons to make your
selection. When you have chosen your desired function, press the Enter button to confirm the change.
DMX address setting - When controlling the unit (or units) with a DMX controller, each one must be set with a specific DMX
address. You can choose to set all units with the same DMX address or you can set every unit with its own DMX address. If all
units are set with the same DMX address all units will be synchronised and operate in the same way.
If you set each unit with a different DMX address, they will receive the DMX signal from their own DMX address. You will now be
able to control each unit individually. The DMX address that you set for each unit must be determined by the number of channels.
This unit has 8 DMX channels, therefore you should set the starting address of the first unit to 1, the second unit must be set to 9
(1+8), the third to 17 (9+8), the fourth to 25 (17+8) and so on.
Number
Display
Function
1
d001-d512
001-512
DMX address setting.
2
IP.01-IP.64
001-512
IP mode.
3
A1.01
A1.01-A1.19
Static colour mode A1.01-A1.32 - press the Enter button to save.
4
A2.01
A2.01-A2.19
Jump change colour mode A2.01-A2.32 - press the Enter button to save.
5
A3.01
A3.01-A3.19
Multicolour mode A3.01-A3.32 - press the Enter button to save.
6
A4.01
A4.01-A4.19
Sound activated mode A4.01-A4.32 - press the Enter button to save.
7
A5.01
A5.01-A5.19
Strobe mode A5.01-A5.32 - press the Enter button to save.
8
r.000-r.255
Adjust the red colour intensity up or down.
9
G.000-G.255
Adjust the green colour intensity up or down.
10
b.000-b.255
Adjust the blue colour intensity up or down.
11
u.000-u.255
Adjust the white colour intensity up or down.