KAM VECTOR6 Instruction Manual - page 6
1. Master/Slave operaton
You can link multiple units together in Master/Slave mode. To achieve this you will need to set the first unit in the chain as the
Master unit and then set all other linked units as Slave units.
Using DMX cables, link the units from the DMX output of the first (Master) unit to the DMX input of the second (Slave) unit, then
link the DMX output of the second unit to the DMX input of the third unit and so on.
Next set the first unit to be the Master:
1. Press the Menu button and choose SLnd
2. Press the Enter button
3. Set the unit to NASt
4. Press the Enter button to confirm your choice
5. Next set the unit to Show mode Shnd (and choose a show (0-16)
Next set the other units to be Slave mode:
6. Press the Menu button and choose SLnd
7. Press the Enter button
8. Set the units to SL1 (normal Slave mode) or SL2 (dual light show mode)
9. Press the Enter button to confirm your choice
All unit should now operate in Master/Slave mode where all units operate the same show as the first unit in the chain. If you are
only joining two units in Master/Slave mode, it is reccomended to us SL2 Slave mode.
2. DMX controller operation
If you intend to operate the unit using a DMX controller, then you need to begin by setting the address. Choose A001 as the
default address. Below are the DMX channel function tables for each DMX mode.
6 channel DMX mode
Channel
Value
Function
1
000-255
Full dimmer 0 - 100%
2
000-255
Strobe, slow to fast
3
000-007
No function
008-022
Show 1
023-037
Show 2
038-052
Show 3
053-067
Show 4
068-082
Show 5
083-097
Show 6
098-112
Show 7
113-127
Show 8
128-142
Show 9
143-157
Show 10
158-172
Show 11
173-187
Show 12
188-202
Show 13
203-217
Show 14
218-232
Show 15
233-247
Show 16
248-255
Sound-to-Light mode
4
000-255
Show mode speed adjustment, slow to fast
5
000-014
Static LED colour change Show
015-255
Colour chase
6
000-255
Colour chase, slow to fast