Kambrook Aquarius Instruction Booklet - Before First Use
7
Operating Your Kambrook Aquarius 1.7L Kettle
Before First Use
Remove any packaging material and
promotional labels before using your
kettle for the first time.
It is recommended before the first use
to fill the kettle to the maximum level
with cold tap water, bring to the boil
and then discard the water. Your kettle
will only operate when positioned
on the power base with the ON/OFF
switch in the ‘ON’ position. The kettle
will automatically switch off once the
water has boiled.
Operation Of Your Kettle
1. To fill the kettle with water, remove
it from the power base and press
the button located on the handle
to cause the lid to lift upwards. Fill
with the desired amount of water.
Do not operate the kettle without
water. Always fill the kettle between
the minimum and the maximum
marks on the water window. Too
little water will result in the kettle
switching off.
2. Ensure that the lid is closed and
locked firmly into place before
placing the kettle on the
power base.
3. Place the kettle firmly onto
the power base and plug the
power cord into a 230V or 240V
power outlet and switch on.
4. Press the ON/OFF switch to the
‘ON’ position. The power ‘ON’
light will illuminate.
cAutION: Never
operate the kettle dry -
too little water will result
in the kettle switching
‘OFF’. Do not overfill
the kettle - filling above
the maximum mark on
the water window may
result in boiling water
splashing from the kettle.
cAutION: This kettle
must only be used
with the power base
supplied. Use caution
when pouring water
from your kettle, as
boiling water will scald.
Do not pour the water
too quickly.
cAutION: Do not
remove the kettle from
the power base during
operation. Ensure the
kettle has switched to the
‘OFF’ position after the
water has boiled before
removing the kettle from
the power base.
5. The kettle will automatically switch
‘OFF’ once the water has boiled. Lift
the kettle from the power base and
pour the water. Take care to hold
the kettle level, especially when
filled to the maximum level. To re-
boil it may be necessary to wait for
a few seconds to allow the control
to reset.