Kambrook Captiv 12V Turbo Instruction Booklet - To Operate The
8
Operating Your Kambrook Handheld Vacuum
continued
Tochargethebattery:
1. Plug charger into a a 230V or
240V power point and switch the
power ‘ON’ at the power point.
2. Ensure the handheld vacuum is
switched to the ‘OFF’ position
before charging.
3. Ensure the recharging pin of the
handheld vacuum charger and
the recharging socket of the
charging base is connected.
4. Slide the handheld vacuum
downward onto the charging
base making sure the handheld
vacuum sits firmly onto the
charging base (see Fig.2).
Fig. 2
5. The red battery charging light
will illuminate indicating that
the handheld vacuum is
being charged.
6. To maintain charge, keep
the charger plugged into a
standard wall outlet and charge
the handheld vacuum after
each use. When charging, the
charger may be warm to touch;
this is normal. It is impossible to
overcharge the battery because
the handheld vacuum is
designed with overcharge
protection circuitry.
WARNING: Always
recharge this appliance
after each use to extend
the life of the battery.
To Operate the
Handheld Vacuum
Your handheld vacuum is designed
for picking up dry debris such as dirt,
dust, pet hair and food crumbs. It
is suitable for use on counters, bare
floors, rugs, tiles, car interiors, and
upholstered furnishings.
1. Once the handheld vacuum is
fully charged, the LED battery
charging light will be green.
Remove the handheld vacuum
from the charging base to use.
2. Slide the power On/Off switch
forward to the ‘ON’ position.
3. Once vacuuming is complete,
slide the power On/Off switch
backwards to the ‘OFF’ position.
4. Empty the dust canister, clean the
filter and then replace both onto
the handheld vacuum before
remounting on the charging
base (see ‘ Emptying the Dust
Canister’on page 10).
NOTE: Slide the power On/
Off switch to the ‘OFF’ position
between cleaning tasks to
conserve power.