Kambrook CaptivG3 Cyclonic Instruction Booklet - Cleaning and

11

Cleaning and  

Replacing Filters

To assist you with the regular care of 

your vacuum, a second HEPA filter is 

supplied for convenient use, ideal for 

when a dirty filter is being cleaned.

NOTE: It is recommended that 

filters are cleaned after every 

use and replaced regularly to 

ensure maximum efficiency from 

your vacuum.

If filters are left uncleaned, it may 

result in a reduction of suction power. 

Should this occur, the following 

procedure should be followed every 

couple of months.

NOTE: The performance 

indicator light may illuminate 

when filters need replacing or 

cleaning.

Procedure to Replace Filters

Always switch the vacuum off,  

then switch off at the power outlet 

and unplug prior to cleaning or 

replacing the filters. Before replacing 

the filters ensure all dirt and dust is 

first emptied from the dust container. 

Refer to the ‘EMPTYING THE DUST 

CONTAINER’ section.

1.  Remove the dust container from 

the vacuum by pressing down 

on the button on top of the 

dust container. Once released, 

carefully lift the container 

upwards. 

Your new vacuum cleaner 

includes a black foam filter casing 

which locks your foam filter to the 

front side of the HEPA filter. This is a 

reusable, removable part. 

Fig. 11

2.  To remove the HEPA filter from 

the back (flat side) of the dust 

container, press the tab and pull 

out the HEPA filter, followed by the 

foam filter and black casing.

Fig. 12

When conducting your routine 

cleaning of the filters, it is 

necessary to remove the black 

foam casing to separate the 

foam and HEPA filters for cleaning.