Kambrook KBV420 Instruction booklet - Operating Instructions

7

Operating Instructions

Before First Use

Remove any promotional material 

from the vacuum cleaner.

When unpacking the vacuum cleaner 

check to see you have received all 

the required components, such as the 

hose and other accessories before 

discarding the packaging.

To Operate the  

Vacuum Cleaner

Locate the crush proof hose and 

push the connection point into the 

hose inlet connection on the front 

side of the vacuum, until a “click” 

sound is heard.

Connect the wide end of the metal 

wand to the hose end, and push 

together firmly.

Fit the floor tool to the narrow end of 

the wand and push together firmly. 

Fully extend the power cord by pulling 

the power plug out from the rear of 

the vacuum, until the yellow tape on 

the cord is showing.

NOTE: Ensure that you do not 

over extend the power cord 

– do not extend past the red 

warning tape on the cord.

Plug into a 230V or 240V power point  

and switch the power on at the 

power point.

To commence vacuuming, push 

down on the on/off button

on/off

cord

press

& lift

up

down

on the 

top of the vacuum cleaner.

When vacuuming is complete, push 

down on the ‘on/off’ button to 

switch off. Turn the power off at the 

outlet and then remove the power 

cord from the power outlet. When 

removing the plug from the power 

outlet, grasp the plug not the cord.

To retract the cord push down on the 

‘cord rewind’ button

on/off

cord

press

& lift

up

down

on top of the 

vacuum cleaner.

IMPORTANT: Hold the 

plug end and guide the 

cord into the vacuum 

during retraction to 

prevent it from striking 

you or the vacuum.

CAUTION: Always 

ensure that the dust 

container and the 

motor protection filter 

are correctly fitted. 

Never operate without 

the dust container or 

filters in place.

Fig. 1

Fig. 2