Kambrook KCL10 Series Instruction Manual
KCL10, KDL30 and KDL40
Series Desk Lamp
KCL10/KDL30/KDL40
GGOO
OODD NNAAMMEE
G GOO
O ODDVV
A ALLUU
E E
PLEASE READ AND FOLLOW THE
INSTRUCTIONS PRIOR TO USING
YOUR DESK LAMP.
Only use maximum 60 Watt incandescent
B22 type globe with this fitting (No globe
is supplied with the fitting).
Always place the incandescent globe into
the fitting without the lamp connected to
the 230-240 Volt mains supply.
Ensure the lamp lead is fully unwound
before turning on.
Keep the power cord well clear of the
lamp shades and maintain clear access to
the cord line switch (KCL10 / KDL40
series only) at all times.
Arrange cord away from traffic areas and
where it will not be tripped over.
Ensure the “On/Off” switch is in the
“Off” position prior to plugging the lamp
into the 230-240 Volt mains supply.
The desk lamp is not intended for
outdoor, wet or moist location. Do not
immerse or allow water to be spilt on the
desk lamp.
Avoid touching lamp shade while it is on,
some parts of the lamp may become hot.
When moving the lamp, switch off, allow
cooling down and hold the lamp by the
body when carrying.
Keep combustible materials such as
drapes and other furnishings well clear of
the lamp shade, as the lamp shade may
become hot if the lamp is left operating
for a period of time.
Extreme caution and supervision is
necessary when this lamp is used by or
near children, invalids or animals.
Young children should be supervised to
ensure they do not play with the lamp.
When not in use, pack the desk lamp in
its original box for best protection and
store in a cool, clean and dry location
Always turn off and then unplug the desk
lamp before cleaning
Do not attempt to open or work on
the desk lamp at anytime, there are no
customer serviceable parts inside. Please
return the desk lamp to Kambrook or
an authorised service agent for service
or repairs.
Use this desk lamp only as described in
this instruction manual. Any other use not
recommended by the manufacture may
cause fire, electric shock or injury and
voids all warranties.
IMPORTANT NOTE FOR THE
KCL10 AND KDL40 SERIES
LAMPS.
The clamping mechanisms for this series
of lamps may damage raw timber surfaces
when left in the same position over a
period of time. Please choose the desired
surface carefully.
The KDL40 series desk lamp is designed
to extend into the desk area. Do not
extend the KDL40 series lamp away from
the desk it is mounted to as this may
place undue stress on the edge of the
desk and result in damaging the desk
and/or lamp.
Issue 2/04