Kambrook KFA423 Instruction Booklet - To Operate The Kambrook

8

NOTE: The Inner Extension Tube is 

inside the Outer Extension Tube. 

4. 

Mount the pre-assembled Fan Head to 

the Inner Extension Tube and tighten  

the Fan Head Screw until it is tight (Fig. 5).

Fig. 5

IMPORTANT: The prongs 

on the pre-assembled fan 

head assembly may  

need to be pried apart 

slightly to more easily fit  

on to the top of the 

extension tube. Do not 

force the pre-assembled 

fan head onto the 

extension tube.

5. 

Press the two Tilt Adjustment Knobs 

firmly on to the bolts located on  

either side of the fan head. (Fig. 6)

Fig. 6

To Operate the Kambrook 

Arctic HV Pedestal Fan

Plug the cord into a 230V or 240V power 

point and switch on.

The fan has 3 speeds. To adjust the flow of 

air, turn the fan speed dial located at the 

back of the fan to the preferred speed - 

LOW, MED or HIGH. To turn Off, turn the fan 

speed dial to the OFF position.

NOTE: To avoid an electrical 

circuit overload, it is 

recommended that no other 

appliances are plugged into the 

same circuit as your fan when it 

is in use.

Adjusting Air Flow Direction

To adjust the flow of air left or right, manually 

swivel the fan to the desired position.

To adjust the flow of air up or down,  

slightly loosen the two tilt adjustment 

knobs located on either side of the 

fan and tilt the fan either upwards or 

downwards to suit. Once the fan is in  

the desired position, re-tighten the  

two knobs to hold in place.

Adjustable Height

The fan height can be manually adjusted. 

Simply loosen the Height Adjustment Knob 

on the Extension Tube of the fan, then adjust 

to the required height. Re-tighten the Height 

Adjustment Knob when the desired height 

has been reached (Fig. 6).

Fig. 6

Using Your Kambrook Pedestal Fan 

continued-