Kambrook KFP80 Essentials Owner's Manual - Attaching The Slicer/grater

5

Attaching the slicer/grater

blades and the processor blade

Using the processor blade:

Place/insert the processor blade over the

processor drive shaft and push down.

Using the slicer/grater blades:

Place the slicing/grating blade over the

shaft adaptor.

The blade is correctly in place, when the

square opening of the slicer/grater blade

fits over the square shaft adaptor.

How to select the slicing or grating

side of the blade

To select the grater have the raised

grating ridges facing up towards the lid.

To select the slicer have the protruding

side of the slicer blade facing up towards

the lid.

All blades must be handled carefully

as they are sharp!

The Essentials Food Processor will not

operate unless the processing bowl, and

lid are correctly locked into position.

Ensure the speed dial is in the Off (0)

position.

Plug into a 230/240 volt power outlet.

Turn power on.

The processor is now ready to use.

To begin processing/slicing/grating turn 

the ‘Power Control Dial’ from the Off (0)

position to either the Low (1) or High (2)

speed, depending on your requirements.

The speed can be changed at any time

during the process.

For short bursts of power, whilst

processing, use the “PULSE” setting.

For slicing and grating – ensure that the

food items you want to slice or grate are

of a suitable size to be fed through the

food chute.

Place the food inside chute and push

down with the ‘food pusher’.

Never push down any foods with your

hands and do not put your hands down

the food chute at any time during

processing.

For using the processing blade – with the

ingredients inside the processor bowl,

start the unit on low speed (1) moving to

the higher speed (2) if necessary. Before

commencing ensure that the ‘food pusher’

is in place to avoid splashing from the

food chute. Ingredients can be added

through the food chute whilst processing.

If ingredients stick to the sides of the

processor bowl during processing, turn

the speed to the Off (0) position, switch

off at the power outlet, then push the

food back onto the blades using a plastic

spatula to scrape down the sides of the

bowl.Then recommence blending.

NOTE: Do not over fill the processor bowl when

mixing liquids – do not fill above the bowls “MAX”

fill line.

When processing is complete, turn to the

Off (0) position.Wait until blades have

stopped rotating before removing the lid,

blades or processor bowl.