Kambrook KKE760CLR Instruction Booklet - Using Your Kambrook Kettle
7
Using Your Kambrook Kettle
Before First Use
Remove any packaging material
and promotional labels before
using your kettle for the first time. It
is recommended before using the
kettle for the first time to fill the kettle
to the maximum (MAX) level with cold
tap water, bring to the boil and then
discard the water.
Your kettle will only operate when
positioned on the power base with
the power On/Off switch in the ‘ON’
position. The kettle will automatically
switch off once the water has boiled.
Operating Your Kettle
1. To fill the kettle with water, remove
the kettle from the power base
and press the one touch pop-up
lid button located on the handle
which will allow the lid to lift
upwards.
2. Fill with the desired amount of
water. Do not operate the kettle
without water. Always fill the kettle
between the ‘MIN’ and ‘MAX’
marks indicated on the glass. Too
little water will result in the kettle
overheating and switching off.
3. Push down on the lid to close,
ensuring that the lid is locked
firmly into place before placing
the kettle on the power base.
4. Place the kettle firmly onto the
power base and plug the power
cord into a 230V or 240V power
outlet and switch on.
5. Press the power On/Off switch to
the ‘ON’ position. The power ‘ON’
light will illuminate blue, indicating
the kettle is heating the water.
6. The kettle will automatically
switch ‘OFF’ once the water has
boiled and the light will extinguish.
WARNING: Do not release
the lid while the water is
boiling. Ensure the lid is
closed whilst boiling.
7. Lift the kettle from the power base
and pour the water. It is important
to hold the kettle level, especially
when filled to the ‘MAX’ mark.
8. To re-boil it may be necessary to
wait for a few seconds to allow
the control to reset.
9. The kettle should be stored on
its power base when not in use.
The power outlet should be
switched off and the power cord
unplugged from the power outlet.
WARNING: Never operate
the kettle dry. Too little
water will result in the
kettle switching ‘OFF’.
Do not overfill the kettle
above the ‘MAX’ mark
indicated on the glass.
This may result in the
boiling water splashing
from the kettle.
WARNING: This kettle
must only be used with
the power base supplied.
Use caution when pouring
water from your kettle, as
boiling water will scald.
Do not pour the water too
quickly.