Kampmann Katherm NX Installation Instructions Manual - Katherm Nx -
11
Katherm NX -
Natural Convection
3.45
Possible Control Options
Room thermostat, surface-
mounted, type 194000146904
Thermoelectric
actuator
Type 194000146905
Valve body 1/2 ",
type 194000246909 or
type 194000346911
Valve body 1/2"
Type 194000146909 or
type 194000346909
Valve body 1/2"
Type 194000146909 or
type 194000346909
Room thermostat, flush-
mounted, type 194000146927
Connection cable
Thermoelectric actuator
Approx. 1,900 mm (should be laid loosely
in the empty duct)
Clock thermostat, surface-
mounted, type 194000146910
Connection cable
Thermoelectric actuator
Approx. 1,900 mm (should be laid loosely
in the empty duct)
Example shown:
Katherm NX 225
with linear grille
Example shown:
Katherm NX 225
with linear grille
Mains
power supply
3 x 1,5
Mains
power supply
3 x 1,5
Mains
power supply
3 x 1,5
Mains
power supply
3 x 1,5
3 x 1,5
3 x 1,5
3 x 1,5
3 x 1,5
Clock thermostat, flush-
mounted, type 194000146933
3 x 1,5
to further thermoelectric
actuators type 194000146905
(total max. 10)
The number of connecting wires required with cable diameters (e.g 3 x 1.5) incl. fuses is given on the individual control units.
Flush-mounted
box (provided
on-site)
Valve body 1/2 ",
type 194000246909 or
type 194000346911
11. Possible Control Options
Note: Always place 194000 in front of the respective type number. e.g. 146904
→ 194000146904
Sample controls
An option for electric controls is the combination of a room thermostat and the
corresponding number of actuators and valves. The required room temperature is set
on the room thermostat. If the room temperature falls below this set value, the
thermoelectric actuator opens the water-side valve.
Thermoelectric
actuator
Type 194000146905