Kane IRP-2 Manual

Summary of IRP-2

  • Page 1

    Kane irp-2 infra red printer stock no: 19056 -6 march 2013 © kane international ltd.

  • Page 2: Operating The Printer

    Page 2 the kane irp-2 is a portable printer using thermal paper that links to other kane products using an infra-red link. It incorporates an ‘easy load’ paper facility and allows nimh batteries to be recharged in situ. Operating the printer button layout and functions fig 1: fig 2: on / off darken ...

  • Page 3: Additional Information

    Page 3 power supply power is supplied to the printer in the form of four aa ni-mh batteries, which can be re- charged by connecting a 19278 charger to the kane irp-2.Fig 2 note: the 19278 cannot supply the full power requirement to the kane irp-2, the batteries must contain some charge before printi...

  • Page 4

    Page 4 replacing the paper roll to replace the paper roll in the kane irp-2, release the paper cover by pressing down the release lever. Remove the old paper roll core and insert the new roll so that it sits as follows :-.

  • Page 5: Status Indicator (

    Page 5 lay the free end of paper over the printer head, past the serrated paper cutter onto the body of the front of the printer’s case. Now close the paper cover and gently press down until it locks into place. Start the paper feed sequence to confirm that the paper has been correctly loaded. Tear ...

  • Page 6: Controlling The Print Head

    Page 6 controlling the print head if you turn the printer off whilst printing, the print head may stop in the middle of the line. To return the print head to the left side of the paper, turn the printer on, then off. Missing or misformed characters the █ character will show on the print out if the p...

  • Page 7: Cleaning

    Page 7 cleaning the outer case and protective boot (if applicable) can be cleaned using a damp cloth and non abrasive detergent. After cleaning leave the product in a warm dry place until the surfaces are completely dry. Under no circumstance use solvent or hydrocarbon based products as they can cau...

  • Page 8: Please Note:

    Page 8 electromagnetic compatibility european council directive 89/336/eec requires electronic equipment not to generate electromagnetic disturbances exceeding defined levels and have adequate immunity levels for normal operation. Specific standards applicable to this analyser are stated below. As t...