KanexPro HDBASE70POE Manual - page 7
KANEXPRO
HDBASE70POE
3
2. Introduction of Product Appearance
2.1
Appearance of HDMI Twisted Pair PoC Transmitter
Figure 2-1 Appearances of HDMI Twisted Pair PoC Transmitter
1)
ON: Working status indicator of this device. When the device works fine, this
green LED will keep blinking. And it will get off when the device stops work.
2)
LINK: Twisted Pair Link status indicator, green LED. It will keep on when
connection is successful.
3)
IN: When connected with devices support HDCP and work normally this LED will
keep on. If devices not support HDCP, this green LED will blink.
4)
POWER LED: LED indicator of power. When connect with power, red LED will
keep on.
5)
HDBT OUT: Connect to the HDBT IN port of HDMI Twisted Pair PoC Receiver
with a CAT5e cable.
6)
HDMI IN: Connect to HDMI source.
7)
IR IN: Connect with IR receiver, the IR signal received from this port can only
send out in HDMI Twisted Pair PoC Receiver.
8)
IR OUT: Connect with IR sender, the sending IR signal are received from HDMI
Twisted Pair PoC Receiver.
9)
RS232: RS232 connector.
10)
DC 24V: Connect with power supply (Not necessary if HDMI Twisted Pair PoC
Receiver connects with power).
Note:
Pictures shown on this manual are for reference only, different model and
specifications are subject to real product.