Drive installation manual ' copyright 2002 document number 2002-104.
Europe this product is in conformity with the emc directive. Fcc tested to comply with fcc standards for home or office use this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this devic...
3 2 read this installation manual completely and carefully before attempting installation this cd-rw&dvd+rw/+r drive together with software is a product for utilizing cd-rw&dvd+rw/+r recording media with rewriting, erasing and readout capabilities, as an external computer memory device. Except in th...
Before you start to install the drive familiarize yourself with the drive controls and connectors. Front panel • headphone jack: for connection to headphone or powered speakers. • volume control: for controlling the volume of the headphones. Moving it to the left reduces the volume, moving it to the...
Step1. Prepare your computer for the drive installation: fig 1 save your files and as a precaution make sure your system back up files are up to date. Now run your shut down procedures. Once shut down is complete, turn off power and unplug your computer. Discharge static electricity and remove your ...
Or ide 1. There should be a second connector close by labeled sec. Or ide 2. If there is a cable plugged into the sec - ide 2 connector follow it and identify the drives connected to it. From fig 3 a/b select the drive ide configuration that you will use for connecting the kano dvd+rw/r drive to you...
Step 4. Connect the optional audio cable fig 5. Connect the audio cable supplied with your kano drive to the analog audio connector fig 5. Step 5. Installing your drive fig 6. If you have attached the optional audio cable slowly feed it into the open drive bay as you slide the drive into the bay. If...
Step 7. Connect the drive power cable fig 8. Caution: drive power connectors only fit one way. Match up the angled corners of the connector with similar corners on the drive dc input connector. Improper connection will damage the drive. Locate an available dc+5v/+12vpower cable in your system and pl...
Drive type: internal half height interface: atapi supported media for writing: dvd+rw, dvd+r, cd-r, cd-rw, high speed cd-rw writing speed: (dvd+rw) 2.4x (dvd+r) 2.4x (cd-r) 2x, 4x, 8x, 12x (cd-rw) 2x, 4x, 10x reading speed: (dvd-rom, dvd+rw, dvd+r) maximum 8x (cd-rom, cd-r, cd-rw) maximum 32x record...
17 16 troubleshooting if these suggestions do not solve your problem contact kano technologies technical support www.Kanotechnologies.Com or call tel: 714-379-5520. This is not a free call consult you local phone service provider for your rates before placing the call. You must have the following in...
