Kappa WST-916 Operation Manual - page 3
1. Switch ‘ON’ the living room load (light).
2. Timer will start the countdown until it reaches 3 hours.
3. After 3 hours, wall switch will automatically send an ‘OFF’ signal to the load (light).
NOTE:
During countdown interval for ON/OFF receiver(s) if;
2
nd
‘ON’ button is pressed, the timer will restart countdown from the beginning.
‘OFF’ button is pressed, will turn ‘OFF’ the load (light) and exist the timer countdown.
During countdown interval for Dimmer receiver(s) if;
2
nd
‘ON’ button is pressed, the load (light) will start to dim and at the desired brightness level press the ‘ON’ button
again. Note the timer will restart countdown from the beginning.
‘OFF’ button is pressed, will turn ‘OFF’ the load (light) and exist the timer countdown.
Operation
ON/OFF Function:
Press the ‘ON’ button on wall switch, the lights will gradually illuminate.
Press the ‘OFF’ button on wall switch, the light will gradually turn OFF.
Dimming Function:
1. Make sure the load (light) is switched ON.
2. On the wall switch press the ON button again, the loads will start to dim.
3. To stop at the desired brightness level, press the ON button again.
※
Dimming level dims in cycle, during the cycle if no signal is given『with 4 cycles it will stop at 100% brightness』.
!
After setting a dim level using the wall switch the light is then switched OFF, the next time that the light is switched back