Kaption Audio AS 100.4 Owner's Manual - page 3
2
FEATURES
1. Amplifiers allow low level input into the RCA type input connections.
Low Level Input - Source units with an output signal level of 100mV-10V may be used. See
"Input Sensitivity" for proper voltage level setting.
2. Input Sensitivity - The Input Sensitivity switch is used to set the proper input voltage range:
3. Gain Control - This feature is used to fine-tune the input sensitivity of the amplifier to the
source unit's output level.
4. LPF - This one band parametric equalizer provides individual frequency.
Q/bandwidth, and+/-12dB gains adjustment controls. Any frequency from 30Hz to 80Hz can be
chosen and boosted or cut up to 12dB. The "Q" ranges from 0.5 to 4.0 in value to allow a wide
variety of bandwidth adjustment and address the subtle tuning requirements common to mobile
audio systems.
6. Speaker Connection -Two sets of speaker terminals are provided for dual woofer
applications. When connecting a single woofer, use only one set of speaker terminals.
7. Power Terminals - This is the main power connection for the amplifier. The power and ground
wire size should be the same gauge.
GND- The ground wire from this connection must be attached to bare metal on the vehicle.
The distance to the ground should be as short as possible and no more than 18".
REM- To turn the amplifier on/off, this terminal must be connected to the source unit's
"remote or electric antenna" wire.
+12V- The power wire from this connection must be attached to the positive side of the
vehicle's battery.
5.HPF- when you are using coaxial or component speaker system, this allows you to adjust
hign-pass x-over frequency from 50Hz to 1000Hz. To get better sound quality from coaxial or
component speaker system, we recommend the frequency should be higher than 65Hz. Make
sure the X-OVER switch is positioned at “HPF”.
13
SPECIFICATIONS
MX 400.1
RMS POWER
MAX POWER
BRIDGED POWER
Min Speaker
Impedance
2 Ohm Stereo
4 Ohm Mono Bridged
Frequency Response
Low Pass
High Pass
Bass Boost
Signal-to Noise Ratio
THD
Fuse Rating
Dimension (W x H x D)
20Hz ~ 20KHz 15Hz~300Hz
1 Ohm
1000w x 1
1500w x 1
125w x 2
300w x 2
235w x 1
180w x 4
120w x 4
200w x 2
Sub Sonic
50Hz ~ 300Hz
50Hz ~ 1KHz
50Hz~300Hz
0dB ~ 12dB
0dB ~ 12dB
15Hz~50Hz
95dB
95dB
35A x3
25A x 2
200x180x 55
312 x180x55 290x180x55
mm
85dB
0.2%
0.01%
0.01%
AS 100.4
MX 1000.1
1 Ohm
0dB ~ 12dB
15Hz~50Hz
15Hz~300Hz
50Hz~300Hz
25A x 2