1 digital monoblock amplifiers d-500.1 dd d-1000.1 d owners manual & installation guide.
Introduction congratulation on your new purchase of kaption audio amplifer. Kaption audio amps are built with the most advanced technology today with superior sound quality to deliver a superb listening experience. We have dedicated ourselves for years in order to offer the best possible quality lev...
Features • digital class “d” mono block amplifier • 2 channels input / mono output • nickel plated high current drain power terminals & speaker terminals • nickel plated rca inputs & outputs • soft remote on / off circuitry • fully 1 ohm mono operation • full mosfet circuitry • variable input level ...
Functions 1. Power connection terminal • battery + +12v power cable must be connected directly to the positive terminal of the battery with an in-line protection fuse, not to the electrical system of the car (i.E., fuse block). • rem: remote turn on connect this terminal to the source unit’s power a...
4. Bridge module • allows for the two amplifiers to be run in series and achieve double the output into one load. 5. Power indicate led • lights blue when the power turns on. 6. Protection indicate led • lights red when the short protection operates. 7. Low level inputs • these are the low level sig...
13. Subsonic filter selection switch • subsonic filter on/off control switch 14. Phase switch • adjust the speaker phase to either 0 or 180 degrees. 15. Variable subsonic filter frequency adjustment • adjust from 15hz to 50hz with a slope of 24db per octave. This allows for the attenuation of freque...
Power supply connections all power connections are made via a nickel-plated terminal strip at one end of the amplifier chassis. It is highly recommended that you read the following precautions and contact you’re nearest authorized dealer if you are unsure of any details. Before installations make su...
Make sure that your vehicle’s electrical system (i.E., alternator, battery, etc.) is capable of handling the additional load. If you are planning a multi-amplifier system, you may need to add a second battery and possibly upgrade the alternator with a higher output rated model. Consult your authoriz...
Wiring diagram (single amplifer setup) input wiring diagram speaker wiring diagram 8.
Bridging mode using two amplifiers 9.
Caution when wiring 2 amplifiers in bridged mode to 1 speaker, connection (1) linking master amplifier to slave amplifier must be wired first. Connection (2) must be performed next between master and slave amplifier. Once connected, the speaker connection can be made to the master and slave amplifie...
Kaption audio 399 four valley dr, unit 27 concord, ontario, canada l4k 5y7 1-866-kaption (527-8466) 3333 391 1 www.Kaptionaudio.Com.
