Karaoke Night KN200 User Manual - page 8
USING AUX IN FUNCTION
This feature allows you to listen to an external audio source through the speakers of this unit.
1.
Plug a 3.5mm audio cable (not included) into the headphone jack of your external audio player (not
included) and connect the other end (3.5mm plug) into the AUX IN jack on the rear side of this unit.
2.
Make sure both units are turned on.
3.
Play a song on your MP3 or MP4 player.
4.
Adjust the volume control of your audio player and then the MASTER VOLUME CONTROL of the unit to
obtain the desired audio sound level.
5.
Turn off both the external audio player and this unit after use.
CONNECTING THE MICROPHONE
WARNING - Tapping or dropping the microphone while it is on can permanently damage your microphone.
Do not swing the microphone around by the cord.
Note: To prevent feedback or whistling from occurring, please be sure that the microphone is not too close to
unit’s speakers.
1.
Connect the supplied Microphone to either one of the MIC input jacks.
2.
Press the POWER ON/OFF button to turn on the Karaoke system, the POWER INDICATOR will light.
3.
Slide the ON/OFF switch located on the Microphone to the ON position and speak or sing into the
Microphone. The Microphone sensitivity and loudness can be adjusted by turning the corresponding MIC
VOLUME control and/or MASTER VOLUME control.
4.
Turn off the unit after use by pressing the POWER ON/OFF button again. The POWER INDICATOR will
go off.
INSTALLING AND REMOVING A DISC
Make sure nothing is connected to the AUX IN JACK and press the POWER ON/OFF button to power up the
unit. Pull on the CD DOOR LATCH to open. Hold the CD by the edges with label side facing front and mount it
vertically into the CD compartment. Press the CD DOOR to close.
7
EXAMPLE OF EXTERNAL AUDIO PLAYER
To
headphone
output