Karcher 2000 G Operating Instructions Manual

Other manuals for 2000 G: Operating Instructions Manual
Manual is about: Karcher 2000 G Pressure Washers: User Guide

Summary of 2000 G

  • Page 1

    Operating instructions kÄrcher 2000 g before putting the cleaner into operation, please read the operating instructions carefully. 5.951-875 f 01193 2.93.

  • Page 2

    I. I m p o r t a n t n o t e s ii. O p e r a t i o n iii. A p p l i c a t i o n s iv. M a i n t e n a n c e v. T r o u b l e - s h o o t i n g vi. T e c h n i c a l d a t a 1. Transport ............................................. 4 2. Safety precautions .......................... 4 3. Fuel recomme...

  • Page 3

    11 12 13 10 5 14 16 15 17 18 16 bracket 17 model, type and serial numbers 18 spark plug 19 high-pressure hose 20 trigger gun 21 spray lance with changeover nozzle schematic drawing 1 fuel fill 2 oil fill with oil dipstick 3 starter grip 4 carburetor 5 muffler 6 flywheel guard 7 governor control leve...

  • Page 4

    4 i. I m p o r t a n t n o t e s before putting the unit into operation, please note the following points: 1. Transport • if, while unpacking the unit, you discover that it has become damaged during transport, please notify your dealer or your kärcher sales office. 2. Safety precautions warning • do...

  • Page 5

    5 i. I m p o r t a n t n o t e s suction operation it is also possible to draw water by suction from an open tank. • if this is required, the cleaner should be fitted with a suction hose with filter (kärcher order no. 4.440-238). • the level of the water must not be more than 3 ft below the unit. Im...

  • Page 6: II.   O P E R A T I O N

    6 ii. O p e r a t i o n 2. Start engine - move engine control lever to "choke" position. - grasp starter grip as illustrated and pull slowly until resistance is felt. - then pull cord rapidly to overcome compression, pre- vent kickback and start engine. - repeat if necessary with engine control leve...

  • Page 7: II.   O P E R A T I O N

    7 ii. O p e r a t i o n 3. High pressure operation - release the safety lock on the trigger gun . - squeeze and hold the trigger gun in open position. In the event of a lengthy break (more than 10-15 minutes) switch the unit off to prevent damage caused by overhea- ting. Safety measures the water je...

  • Page 8: II.  O P E R A T I O N

    8 ii. O p e r a t i o n 6. After use - run clean water through the unit to flush after spraying detergent. - stop the engine move control knob to "slow", then "stop" position. - shut off water supply. - squeeze trigger of gun until no further water emerges. - release trigger and secure with safty lo...

  • Page 9

    9 iii. A p p l i c a t i o n s 2. Detergents kärcher offers a variety of detergents for all your cleaning needs. Order no. Vehicle wash 6.291-778 4 x 1 gal degreaser 6.291-779 4 x 1 gal vehicle wax 6.291-780 4 x 1 gal house wash 6.291-781 4 x 1 gal • check with your local retailer for availability. ...

  • Page 10

    10 iv. S e r v i c e a n d m a i n t e n a n c e 1. Maintenance intervalls follow the recommended maintenance schedule and make in-between checks. This will help you obtain maximum engine life. Caution: to prevent accidental starting when ser- vicing the unit, always remove the spark plug or wire fr...

  • Page 11

    11 iv. S e r v i c e a n d m a i n t e n a n c e f. Change motor oil oil recommendations we recommend the use of a high quality detergent oil such as sae 30 or detergent oil classified “for service sc, sd, se, sf, sg”. Detergent oils keep the engine cleaner and retard the formation of gum and varnis...

  • Page 12

    12 iv. S e r v i c e a n d m a i n t e n a n c e g.Clean spark arrester (optional) - if engine is equipped with spark arrester screen assem- bly, remove for cleaning and inspection. - replace if damaged. H. Clean cooling system remove the blower housing to remove the blower housing remove three scre...

  • Page 13

    13 2. Repairs for service and repairs on the pump please contact a kärcher authorized service center. For service and repairs on the engine please contact a briggs & stratton authorized service center. To serve you promptly and efficiently, the service center will need the model, type and serial num...

  • Page 14

    14 v. T r o u b l e - s h o o t i n g vi. T e c h n i c a l d a t a caution: to prevent accidental starting when servicing the unit, always remove the spark plug or wire from the spark plug. No adjustments should be made to any parts that are sealed. Fault cause remedy engine will not start - fuel t...