Karcher 650 MB User Manual - 4.4 End of Operation

14

4.4 End Of Operation

ALWAYS REMEMBER TO RINSE YOUR PRESSURE WASHER

AFTER USING DETERGENT BY FILLING THE DETERGENT

CONTAINER WITH CLEAN WATER AND RUN THE PUMP FOR

APPROXIMATELY ONE MINUTE

In the event of a break of 5 minutes in the operation of your

Karcher Pressure Washer, always switch off the pump to

avoid damage due to overheating.

• Switch off the pressure washer by the Power Switch (No.4) and

unplug the Mains Electric Lead (No.5) from the socket.

• Close the water inlet (tap) and disconnect the hosepipe.

• Squeeze the lever to remove all pressure from the machine.

Release the lever and then secure the trigger with the Safety

Locking Device to prevent accidental opening.

4.5 STORAGE

The Spray Gun (No.12), the Wash Brush (No.17)

and the Spray Lance (No.16) can be stored with

the Pressure Washer.

The Mains Electric Lead (No.5) can be wound up

over the Mains Lead Storage (No.6).

5. IMPORTANT – CARE AND MAINTENANCE

To ensure prolonged life and trouble-free use of your

Karcher Pressure Washer we strongly recommend

that you always adopt the following procedures:

Water

• Before use, always check the inlet filter for dirt or debris.

• Visually check to see if the nozzle is blocked by dirt or grit, if so,

remove the dirt from the nozzle hole with a needle and rinse with

water from the front.