Karcher A 2656 X Operating Instructions Manual - Maintenance and Care
10
English
몇
Always use a filter bag while sucking
in fine dust!
Î
Change filter bag earlier if you vacuum
cleaning fine dust particles for a longer
period.
Î
Please use the pre-separator accesso-
ry (order no.2.863-139) to such in ash.
Vacuuming hard surfaces
Illustration
Use your foot to press the reversing switch
of the floor nozzle. The brush strips at the
bottom of the floor nozzle are extended.
Vacuuming carpeted floors
Illustration
Use your foot to press the reversing switch
of the floor nozzle. The brush strips at the
bottom of the floor nozzle are retracted.
Î
Use the surrounding air separator to
adapt the suction force.
Note: Close the surrounding air separa-
tor again after use!
Use this function, for example, to blow out
leaves or dust from the garage, hobby
room, work shop, courtyard or garden.
Illustration
Î
Connect connection hose. Open the
slide of the air regulation, and select the
desired blowing performance.
몇
Caution:
Do not use a filter bag!
Immediately switch the appliance off if foam
forms or liquids escape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
Illustration
Î
Turn off the appliance and disconnect
the mains plug.
Empty the container
Illustration
Î
Press the unlocking mechanism by foot
and remove the vacuuming device from
the chassis.
Illustration
Î
Remove the motor casing and empty
the container.
Î
Insert the vacuuming device in the
chassis - the container is self-locking.
Storing the Appliance
Illustration
Î
Place the accessories in the appropri-
ate compartments at the appliance and
store the appliance in a dry room.
Î
The large wheels facilitate transporta-
tion on stairs; hold the device at the
transport handle while doing so.
Note: Never transport the device at the
handle of the vacuuming device; risk of
tilting!
Î
The device is to be fastened properly be-
fore transporting the device in the car.
Note: We recommend that you first re-
move the vacuuming device from the
chassis.
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
몇
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
Î
Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
Î
If required, rinse the container and ac-
cessories with water properly and dry
them before reuse.
Blowing function
Wet vacuum cleaning
Finish operation
Transporting the device
Maintenance and care
Cleaning the appliance and acces-
sories