Karcher antares User Manual - Power Supply
EN | 13
EN
Power Supply
•
The capacity of the built-in battery is 3.7V, 290mAh.
•
To charge the battery, connect the headphones via the supplied USB cable to a computer
(computer must be switched on). Under normal circumstances the charging takes about 3
hours. During charging the headphones can be either turned off or on (charging will take
slightly longer, especially when music is being streamed).
•
While charging, the charge indicator is lit red.
• Once the charging is finished, the LED indicator will switch off.
•
To switch the headphones on, set the
ON/OFF
switch to “ON”.
•
Always switch the unit off after use by switching the
ON/OFF
switch to “OFF”.
•
Playback time of the battery is about 10 - 12 hours (depending on the volume and audio
source).
Note:
The USB port on this product is only for charging. It cannot communicate with a computer and can-
not be used for connecting other devices for playback.
Bluetooth
®
Connection
Settings on the Headphones
•
Turn the headphones on by setting the
ON/OFF
switch to “ON”.
•
When no device is connected the LED indicator will be blinking blue slowly. An external
device can now be paired and connected to the headphones.
Settings on Your Device
1.
Turn on the
Bluetooth
®
feature on your device.
2.
Search for
Antares
.
3.
Pair and connect to
Antares
. If prompted for a password, enter “0000”.
4.
Pairing successful and ready to stream music. The LED indicator will blink blue twice every
5 seconds.
Notes:
•
The above illustration is just an example of a device’s menu. The menu of your device might
look differently.
•
Antares
will automatically connect to a previously paired device if both are switched on and
within reach of each other.
•
To disconnect
Antares
from your device, you can either do so on your device or press and