Summary of BR 400
Page 1
Br 400 5.956-013 10/00 www.Karcher.Com.
Page 2
Deutsch 1 deckel für bürstenwalze 2 schrauben 3 arretierung für transport-/ arbeitsstellung 4 fußpedal für saugbalken 5 schubbügel 6 saugbalken 7 bürstenwalze 8 schmutzwasserbehälter 9 frischwasserbehälter 10 linker und rechter schalthebel 11 sprühknopf 12 einfüllöffnung frischwasserbehälter 13 stec...
Page 3: Table of Contents
Br 400 10 english table of contents 1. Operation ..................................................................................................... 11 attaching the push handle ........................................................................... 11 transport position/working position ........
Page 4
Br 400 11 english 1. Operation attaching the push handle filling the detergent solution note: please comply with the manufacturer´s metering instructions and ensure that the detergent solution is well mixed. • when filling using a hose or a bucket, open the cover of the fresh water container and fil...
Page 5
Br 400 12 english operating in normal mode • connect the unit plug to the extension cable and hook into the cable grip on the push handle. Û • insert the extension cable plug into the mains socket. • turn knob to set brush contact pressure to desired amount. Ü start at a low setting and increase pre...
Page 6
Br 400 13 english caution: the transport position can only be selected when the push handle is in a vertical position. Position the push handle vertically when turning off the unit in order to avoid damaging the brushes. • the floor cleaning unit is equipped with four, small-diameter transport wheel...
Page 7
Br 400 14 english 2. Care and maintenance caution: switch off the unit and disconnect the mains plug before cleaning, servicing or repairing. Repair work must only be carried out by authorized customer service centres familiar with the safety regulations. Do not use a hose or high pressure water spr...
Page 8
Br 400 15 english protection against freezing • if there is a risk of freezing, run the pump until no more water comes out. The best protection is to store the unit in a room which is above freezing point. • when restarting the unit after freezing, fill the tank with warm water and wait until any ic...
Page 9
Br 400 16 english 3. Technical data 1.926-721 1.926-281 1.926-691 1.926-521 1.926-591 1.926-121 1.926-291 rated voltage 220 v/230 v (1~50hz) 230 v (1~50hz) mains fuse (slow) 16 a* (gb: 13 a) 10 a rated power 2.54 kw 2.1 kw – brush motor 1.7 kw 1.5 kw – vacuum motor 0.8 kw 0.55 kw – spray pump 0.04 k...
Page 10
Br 400 17 english 4. Troubleshooting you may be able to rectify some malfunctions by yourself. Malfunction possible cause remedy no or insufficient detergent solution on floor fresh water tank is empty fill up connection between fresh water tank and pump leaks check connection pump defective call cu...
Page 11
Br 400 18 english further malfunctions br 400 insufficient suction power or unsatisfactory vacuuming result on the floor dirty water tank incorrectly mounted on the unit check and mount correctly water level in the dirty water tank too high empty dirty water tank excess-current circuit-breaker has t...
Page 12: Br 400
5.003-029.0 a 5.181-040.0 1 5.181-041.0 2 (standard/ standard/ standard/) 1 (ölfest/ oil resistent/ resistant à l'huile/) 2 12.09.2000 4.692-025.0 5.028-754.0 5.585-020.0 5.031-066.0 5.070-480.0 4.066-238.0 4.063-241.0 7.311-003.0 4.481-080.0 6.343-132.0 6.435-267.0 5.063-650 5.321-457.0 5.031-407.0...