Karcher G 2000 QT Operator's Manual

Other manuals for G 2000 QT: User Manual
Manual is about: Karcher G 2000 QT Pressure Washers: User Guide

Summary of G 2000 QT

  • Page 1

    G 2000 qt 9.139-137 (06/04) english.

  • Page 2: Specifications

    2 high pressure washer operator manual overview ........................................................................ 3 precautions ................................................................... 4 assembly instructions .................................................. 5 operating instructio...

  • Page 3: Model G 2000 Qt  Overview

    3 model g 2000 qt overview item description 1. Handle 2. Water inlet with garden hose connector 3. High pressure outlet 4. Detergent suction tube 5. Detergent filter 6. High pressure hose 7. Trigger gun safety lock 8. Trigger gun 9. Spray wand with high/low pressure nozzle 10. Oil fill cap 11. Pull ...

  • Page 4

    4 important precautions – read first! Important safety instructions warning – when using this product basic precautions should always be followed, including the following: warning – risk of injection or injury – do not direct discharge stream at persons. • read all the instructions before using the ...

  • Page 5: Assembly Instructions

    5 assembly instructions step 1 push the clip from the other side if it is completely set. Use a small screwdriver to help push out of the locking clip. Step 2 insert the small end of the high pressure hose into place. Step 3 push the locking slide back into the trigger gun to lock the hose in positi...

  • Page 6: Operating Instructions

    6 operating instructions step 1 check oil level. Oil level should always be between the “full” and “add” marks on the dipstick. Be sure the machine is level when checking the oil level. (refer to the engine’s operating manual for seasonal grades.). Step 2 fill gas tank with unleaded gasoline. Do not...

  • Page 7: Using The Accessories

    7 high/low pressure nozzle this nozzle features two positions. The high setting provides a steady powerful 25° high pressure spray pattern, for general cleaning. The low setting creates a wider 40° low pressure pattern. Note: detergent is applied with the nozzle set at low pressure. Using the access...

  • Page 8: Working With Detergents

    8 working with detergents detergents can only be applied in the “low” setting. Step 1 set the spray wand to the low pressure (-) position. Step 2 adjust the filter end of the detergent tube for light (– / 0.13 gpm), or maximum (+ / 0.18 gpm) detergent coverage. Step 3 fill a container with kärcher d...

  • Page 9: Shutting Down & Clean-Up

    9 shutting down & clean-up shutting down step 1 remove detergent suction tube from container and insert into 1 gallon of fresh water. Siphon water at low pressure for one minute. Step 2 turn off the engine. Step 3 turn off the water source. Step 4 press trigger to release water pressure. Step 5 disc...

  • Page 10: Cleaning Tips

    10 cleaning tips deck cleaning (with or without detergent) pre-rinse deck and surrounding area with fresh water. If using kärcher deck & patio cleaner, (canada: deck + fence wash) place detergent suction tube directly into cleaning solution and apply to surface at low pressure. For best results, lim...

  • Page 11: Cleaning Tips –

    11 cleaning tips – continued barbecue grills, outdoor power equipment & gardening tools (with or without detergent) pre-rinse cleaning surface with fresh water. If using kärcher all purpose and vehicle wash or heavy duty degreaser (canada: pressure wash or degreaser), place detergent suction tube di...

  • Page 12: Troubleshooting

    12 please remove the spark plug cable to prevent accidental ignition of the engine before making any repair. Engine will not start. • no gasoline. - fill gas tank. • low oil level - add oil. • engine is not primed. - push primer ball three times. • engine throttle is not in correct position. - posit...

  • Page 13: Troubleshooting –

    13 troubleshooting – continued garden hose connection leaks. • loose fittings. - tighten fittings. • missing/worn rubber washer. - insert new washer. Spray wand leaks. • spray wand not properly attached. - insert the spray wand into the trigger gun. Carefully press in against the spring tension and ...

  • Page 14: Manual Del Operador

    14 manual del operador generalidades ............................................................. 14 precauciones .............................................................. 15 instrucciones de ensamblaje ..................................... 16 instrucciones de operación ..........................