Karcher HD 10/25 S Plus Operating Instructions Manual - Preparing The Unit For Use

Operating Instructions HD 10/25 S/SX Plus, 13/18 S/SX Plus

English

16

Preparing the unit for use

Unpack the unit

– When unpacking the unit, check the con-

tents of the packaging. If there has been 

any damage in transit inform the dealer.

– Do not dispose of the packaging with the 

household rubbish, hand it in at the appro-

priate collection point for recycling.

Check the oil level

Read the oil level displayed while unit is at 

a standstill. The oil level must be above the 

two indicators.

Activate the oil reservoir vent

Unscrew the fastening screw of the hood 

and remove the hood.

Cut off the tip on the cover to the oil reser-

voir.

Fasten the unit cover.

Mount the accessories

Mount nozzle on the spray lance (see 

markings on the top of the setting ring).

Fit the spray lance to the hand-held spray 

gun with pressure and flow control.

For appliances with hose reel:

Insert the crank handle into the hose drum 

shaft.

Connect the high-pressure hose to the 

handgun.

For appliances without hose reel:

Lock cable clincher into bore lateral to the 

handle.

For handguns with threaded connection:

Tighten the high-pressure hose according-

ly.

For handguns without threaded connection:

Lever off retaining clasp on handgun with a 

screwdriver.

Stand handgun on end and while holding it 

in this position, push end of hose into pistol 

as far as end stop. Ensure that loose disc 

on end of hose drops all way to bottom.

Push retaining clasp back into handgun. 

When attached properly, high-pressure 

hose can only be pulled out by approx. 

1 mm. If hose can be pulled out further, the 

disc has been incorrectly fitted.

It is advisable to lay the high-pressure hose 

out in a straight line before reeling it up.

Wind the high-pressure hose up in even 

layers on the hose reel by turning the crank 

handle.