English 2 español 19 français 36 k 2.350 59633970 09/09.
2 english danger indicates “an imminently hazardous situ- ation which, if not avoided, will result in death or serious injury.” warning indicates “a potentially hazardous situa- tion which, if not avoided, could result in death or injury.” caution indicates “a potentially hazardous situa- tion which...
English 3 1 high pressure outlet 2 on/off switch 3 hose/cord hook 4 handle 5 spray wand storage 6 water inlet with garden hose connector 7 detergent suction tube with filter 8 power cord with ground fault circuit interrupter (gfci) 9 wheels 10 trigger gun 11 trigger gun safety lock 12 locking slide ...
4 english warning when using this product basic precau- tions should always be followed, includ- ing the following: read all the instructions before using the product. To reduce the risk of injury, close su- pervision is necessary when a prod- uct is used near children. Know how to stop the product ...
English 5 this system is capable of pro- ducing 1600 psi to avoid rup- ture and injury, do not operate this pump with com- ponents rated less than 1600 psi working pressure (includ- ing but not limited to spray guns, hose and hose connec- tions). Before servicing, cleaning or removing any parts, shu...
6 english screwdriver, small size (not supplied) for connecting high pressure hose and trigger gun. Î step 1: insert wheels into the side holes of the unit. Î step 2: slide the transport handle into place. Î step 3: a pull out the locking slide of the trigger gun handle. B insert the small end of th...
English 7 Î step 3: connect garden hose to unit’s water inlet. Î step 4: connect garden hose to the cold wa- ter source and turn water on com- pletely. Î step 5: plug the ground fault circuit inter- rupter (gfci) into a receptacle. Press reset button, indicator should be “on”. Press test button, ind...
8 english warning to avoid serious injury never point spray nozzle at yourself, other per- sons or animals. Always test an inconspicuous area before cleaning with high pressure. The vario power spray wand allows you to adjust the cleaning pressure. To clean at maximum pressure, the wand must be posi...
English 9 detergents can only be applied at low pressure (min.). Î step 1: install the vario power spray wand. Set the spray wand to the low pres- sure setting (mix). Î step 2: fill a container with kärcher deter- gent. Place the filter end of detergent suction tube into the container. Î step 3: tur...
10 english Î step 1: release trigger and engage gun safety lock. Î step 2: turn pressure washer to off (0) po- sition. Î step 1: turn the switch to off (0) position and unplug cord from outlet. Î step 2: turn off the water source. Î step 3: press trigger to release water pres- sure. Î step 4: releas...
English 11 Î 1: disconnect all water connections. Î 2: turn on the machine for a few sec- onds, until the water which had re- mained in the pump exits, turn off immediately. Î 3: do not allow high pressure hose to become kinked. Î 4: store the machine and accesso- ries in a room which does not reach...
12 english caution before cleaning any surface an in- conspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results. If painted surfaces are peeling or chipping, use extreme caution as pressure washer may remove the loose paint from the surface. When using on sur...
English 13 at high pressure in a sweeping motion keeping the spray nozzle approximately 6-8 inches from the cleaning surface (distance should increase when rinsing pin-striping or other sensitive surfaces). Always clean from top to bottom and from left to right. For best results, wipe surface dry wi...
14 english for more effortless cleaning of all smooth surfaces (painted, glass and plastic) try the kärcher ® rotating wash brush. Use it on your automobile, house siding or windows. The water pressure from your pressure washer causes the inner brushes to gently spin, making your cleaning job much e...
English 15 caution disconnect the machine from the power source before making any repair. Troubleshooting symptom cause solution motor will not start on/off switch is in the “off” (0) position. Turn switch to the “on” (i) position power cord is not plugged in. Plug in power cord. Electrical outlet d...
16 english if you encounter any additional difficul- ties not listed, please visit our website. Usa / canada: www.Karcher-help.Com méxico: www.Karcher.Com.Mx no detergent. Detergent is too thick. Dilute detergent, for best re- sults use kärcher ® detergent. Filter on detergent suction tube is clogge...