Summary of K 2.7
Page 1
English 2 español 17 français 33 5.961-627.0 04/05 k 2.7.
Page 2: Specifications
2 english overview 3 important safety instructions 4-5 assembly instructions 6 operating instructions 7 gfci instructions 8 using the accessories 8 working with detergents 9 shut down & clean up 10 taking a break 10 care and maintenance instructions 11 winterizing and long-term storage11 cleaning ti...
Page 3: Model Overview
English 3 1 on/off switch 2 connector for detergent suction tube 3 high pressure outlet 4 water inlet with garden hose connector 5 detergent suction tube with filter 6 dirtblaster® (rotating spray wand) 7 vario spray wand 8 wash brush 9 trigger gun 10 trigger gun safety lock 11 high pressure hose 12...
Page 4
4 english warning when using this product basic precau- tions should always be followed, includ- ing the following: ! Read all the instructions before us- ing the product. ! To reduce the risk of injury, close su- pervision is necessary when a prod- uct is used near children. ! Know how to stop the ...
Page 5: Ground Fault Circuit
English 5 this product is supplied with a ground fault circuit interrupter (gfci) built into the power cord plug. This device pro- vides additional protection from the risk of electric shock. If power is interrupted in the line, the gfci will automatically re-close the circuit to the load after pow-...
Page 6: Assembly Instructions
6 english " step 1, 2: " step 3, 4: " step 5, 6: " step 7, 8: " step 9: " step 10: attach the high pressure hose to the trigger gun. Pull out the locking slide from the right side of the trigger gun handle (a), and insert the small end of the high pressure hose into place (b). Push the locking slide...
Page 7: Operating Instructions
English 7 " step 1: connect the high pressure hose to the unit’s high pressure outlet. " step 2: insert the spray wand of your choice to the trigger gun. Press in against the spring tension and twist into locked position. " step 3: connect garden hose to unit’s water inlet. " step 4: connect garden ...
Page 8: Gfci Instructions
8 english " step 1: plug the ground fault cir- cuit interrupter (gfci) into a working outlet. " step 2: press ’’test’’, then press ’’reset’’ to assure proper connec- tion to power. Note: the actual appearance of the gfci may be different from this illus- tration. Warning to avoid serious injury neve...
Page 9: Working With Detergents
English 9 detergents can only be applied at low pressure (min.). " step 1: install the vario power spray wand. Set the spray wand to the low pres- sure setting (min.). " step 2: fill a container with kärcher deter- gent. Place the filter end of detergent suction tube into the container. " step 3: tu...
Page 10: Shutting Down & Clean-Up
10 english " step 1: turn the switch to off (0) position and unplug cord from outlet. " step 2: turn off the water source. " step 3: press trigger to release water pres- sure. " step 4: disconnect the garden hose from the water inlet on the unit. " step 5: disconnect the high pressure hose from the ...
Page 11: Maintenance
English 11 " 1: disconnect all water connections. " 2: turn on the machine for a few seconds, until the water which had remained in the pump exits, turn off immediately. " 3: do not allow high pressure hose to become kinked. " 4: store the machine and accesso- ries in a room which does not reach fre...
Page 12: House Siding
12 english (with or without detergent). Pre-rinse cleaning surface with fresh water. If us- ing kärcher pressure wash, apply to surface at low pressure (for best results, limit your work area to sections of ap- proximately 6 feet and always apply de- tergent from bottom to top). Allow pressure wash ...
Page 13: Recommendations
English 13 sults, clean from top to bottom and from left to right. ! Before cleaning any surface an in- conspicuous area should be cleaned to test spray pattern and distance for maximum cleaning results. ! If painted surfaces are peeling or chipping, use extreme caution as pressure washer may remove...
Page 14: Soft Clean Washing Brush
14 english made with soft bristles that will not harm painted surfaces. Easily attaches direct- ly to the trigger gun. Ideal for stubborn dirt on cars, boats, patio furniture and other surfaces. Great for applying deter- gent. Fits most karcher pressure was- hers up to 2300 psi. (bayonet) part no. 2...
Page 15: Troubleshooting
English 15 caution disconnect the machine from the power source before making any repair. Troubleshooting symptom cause solution motor will not start on/off switch is in the “off” (o) position. Turn switch to the “on” (i) position power cord is not plugged in. Plug in power cord. Electrical outlet d...
Page 16
16 english call: 1-800-537-4129 for help or visit our website: www.Karcher-usa.Com if you encounter any additional difficul- ties not listed, please call for help. No detergent. Detergent suction tube not properly connected to the machine. Check connection. Detergent is too thick. Dilute detergent, ...