Karcher K 2.93 Original Instructions Manual - Commissioning/ Operations
14
English
The scope of delivery of your appliance is il-
lustrated on the packaging. Check the con-
tents of the appliance for completeness
when unpacking.
In the event of missing accessories or any
transport damage, please contact your
dealer.
Illustrations on Page 2
1 Coupling element for water connection
2 Connection for water supply with filter
3 High pressure connection
4 Detergent suction hose (with sieve)
5 Carrying handle
6 Mains cable with mains plug
7 Appliance switch "0/OFF“/ „I/ON“
8 Trigger gun
9 Lock trigger gun
10 High pressure hose
11 Spray lance with pressure regulation
(Vario Power)
12 Spray lance with Dirtblaster
Special accessories expand the possibili-
ties of using your appliance. Please contact
your KÄRCHER dealer for further informa-
tion.
Illustrations on Page 2
Illustration
Pull out the clamp for the high-pressure
hose from the trigger gun (e.g. with a
small screwdriver).
Connect high pressure hose to trigger
gun.
Push the clamp in until it locks. Check
the secure connection by pulling on the
high-pressure hose.
Note:
Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Push the water supply hose onto the
coupling unit, then connect it to the wa-
ter supply.
Caution
Dry runs lasting longer than two minutes
lead to damages to the high pressure
pump. If the appliance does not build up
pressure within two minutes, switch it off
and proceed as instructed in the Chapter
"Troubleshooting".
Connect the high pressure hose to the
high pressure connection of the appli-
ance.
Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance “I/ON”.
Commissioning/ Operations
Scope of delivery
Description of the Appliance
Special accessories
Before Startup
Water supply
Water supply from mains
Start up